Influence of bio-inspired flow channel designs on the performance of a PEM fuel cell

doi:10.1016/j.cjche.2019.07.010

Abstract

Abstract: Performance of the proton exchange membrane fuel cell (PEMFC) is appreciably affected by the channel geometry. The branching structure of a plant leaf and human lung is an efficient network to distribute the nutrients in the respective systems. The same nutrient transport system can be mimicked in the flow channel design of a PEMFC, to aid even reactant distribution and better water management. In this work, the effect of bio-inspired flow field designs such as lung and leaf channel design bipolar plates, on the performance of a PEMFC was examined experimentally at various operating conditions. A PEMFC of 49 cm² area, with a Nafion 212 membrane with a 40% catalyst loading of 0.4 mg·cm^-2 on the anode side and also 0.6 mg·cm^-2 on the cathode side is assembled by incorporating the bio-inspired channel bipolar plate, and was tested on a programmable fuel-cell test station. The impact of the working parameters like reactants' relative humidity (RH), back pressure and fuel cell temperature on the performance of the fuel cell was examined; the operating pressure remains constant at 0.1 MPa. It was observed that the best performance was attained at a back pressure of 0.3 MPa, 75 ℃ operating temperature and 100% RH. The three flow channels were also compared at different operating pressures ranging from 0.1 MPa to 0.3 MPa, and the other parameters such as operating temperature, RH and back pressure were set as 75 ℃, 100% and 0.3 MPa. The experimental outcomes of the PEMFC with bio-inspired channels were compared with the experimental results of a conventional triple serpentine flow field. It was observed that among the different flow channel designs considered, the leaf channel design gives the best output in terms of power density. Further, the experimental results of the leaf channel design were compared with those of the interdigitated leaf channel design. The PEMFC with the interdigitated leaf channel design was found to generate 6.72% more power density than the non-interdigitated leaf channel design. The fuel cell with interdigitated leaf channel design generated 5.58% more net power density than the fuel cell with non-interdigitated leaf channel design after considering the parasitic losses.

Key words: PEMFC, Interdigitated leaf channel design, Bio-inspired flow field design, Operating temperature, Relative humidity

摘要： Performance of the proton exchange membrane fuel cell (PEMFC) is appreciably affected by the channel geometry. The branching structure of a plant leaf and human lung is an efficient network to distribute the nutrients in the respective systems. The same nutrient transport system can be mimicked in the flow channel design of a PEMFC, to aid even reactant distribution and better water management. In this work, the effect of bio-inspired flow field designs such as lung and leaf channel design bipolar plates, on the performance of a PEMFC was examined experimentally at various operating conditions. A PEMFC of 49 cm² area, with a Nafion 212 membrane with a 40% catalyst loading of 0.4 mg·cm^-2 on the anode side and also 0.6 mg·cm^-2 on the cathode side is assembled by incorporating the bio-inspired channel bipolar plate, and was tested on a programmable fuel-cell test station. The impact of the working parameters like reactants' relative humidity (RH), back pressure and fuel cell temperature on the performance of the fuel cell was examined; the operating pressure remains constant at 0.1 MPa. It was observed that the best performance was attained at a back pressure of 0.3 MPa, 75 ℃ operating temperature and 100% RH. The three flow channels were also compared at different operating pressures ranging from 0.1 MPa to 0.3 MPa, and the other parameters such as operating temperature, RH and back pressure were set as 75 ℃, 100% and 0.3 MPa. The experimental outcomes of the PEMFC with bio-inspired channels were compared with the experimental results of a conventional triple serpentine flow field. It was observed that among the different flow channel designs considered, the leaf channel design gives the best output in terms of power density. Further, the experimental results of the leaf channel design were compared with those of the interdigitated leaf channel design. The PEMFC with the interdigitated leaf channel design was found to generate 6.72% more power density than the non-interdigitated leaf channel design. The fuel cell with interdigitated leaf channel design generated 5.58% more net power density than the fuel cell with non-interdigitated leaf channel design after considering the parasitic losses.

关键词: PEMFC, Interdigitated leaf channel design, Bio-inspired flow field design, Operating temperature, Relative humidity

Srinivasa Reddy Badduri, G. Naga Srinivasulu, S. Srinivasa Rao. Influence of bio-inspired flow channel designs on the performance of a PEM fuel cell[J]. Chinese Journal of Chemical Engineering, 2020, 28(3): 824-831.

Srinivasa Reddy Badduri, G. Naga Srinivasulu, S. Srinivasa Rao. Influence of bio-inspired flow channel designs on the performance of a PEM fuel cell[J]. 中国化学工程学报, 2020, 28(3): 824-831.

References

[1] R.J. Dawson, A.J. Patel, A.E.W. Rennie, S. White, An investigation into the use of additive manufacture for the production of metallic bipolar plates for polymer electrolyte fuel cell stacks, J. Appl. Electrochem. 45(7) (2015) 637-645.
[2] R. Taccani, N. Zuliani, Effect of flow field design on performances of high temperature PEM fuel cells:Experimental analysis, Int. J. Hydrog. Energy 36(16) (2011) 10282-10287.
[3] A.Z. Weber, et al., A critical review of modeling transport phenomena in polymerelectrolyte fuel cells, J. Electrochem. Soc. 161(12) (2014) F1254-F1299.
[4] B. Dawoud, E. Amer, D. Gross, Experimental investigation of an adsorptive thermal energy storage, Int. J. Energy Res. 31(August 2007) (2007) 135-147.
[5] J. Wang, Theory and practice of flow field designs for fuel cell scaling-up:A critical review, Appl. Energy 157(2015) 640-663.
[6] L. Wang, H. Liu, Performance studies of PEM fuel cells with interdigitated flow fields, J. Power Sources 134(2) (2004) 185-196.
[7] Z. Shi, X. Wang, A numerical study of flow crossover between adjacent flow channels in a proton exchange membrane fuel cell with serpentine flow field, J. Power Sources 185(2) (2008) 985-992.
[8] M.V. Williams, H.R. Kunz, J.M. Fenton, Influence of convection through gas-diffusion layers on limiting current in PEM FCs using a serpentine flow field, J. Electrochem. Soc. 151(10) (2004) A1617.
[9] D.H. Jeon, S. Greenway, S. Shimpalee, J.W. Van Zee, The effect of serpentine flowfield designs on PEM fuel cell performance, Int. J. Hydrog. Energy 33(3) (2008) 1052-1066.
[10] Z. Qi, A. Kaufman, Activation of low temperature PEM fuel cells, 111(2002) 181-184.
[11] C. Yang, M. Hu, C. Wang, G. Cao, A three-step activation method for proton exchange membrane fuel cells, J. Power Sources 197(2012) 180-185.
[12] L. Wang, A. Husar, T. Zhou, H. Liu, A parametric study of PEM fuel cell performances, Int. J. Hydrog. Energy 28(11) (2003) 1263-1272.
[13] X.D. Wang, W.M. Yan, Y.Y. Duan, F.B. Weng, G. Bin Jung, C.Y. Lee, Numerical study on channel size effect for proton exchange membrane fuel cell with serpentine flow field, Energy Convers. Manag. 51(5) (2010) 959-968.
[14] X.D. Wang, Y.Y. Duan, W.M. Yan, X.F. Peng, Local transport phenomena and cell performance of PEM fuel cells with various serpentine flow field designs, J. Power Sources 175(1) (2008) 397-407.
[15] J.P. Owejan, T.A. Trabold, D.L. Jacobson, M. Arif, S.G. Kandlikar, Effects of flow field and diffusion layer properties on water accumulation in a PEM fuel cell, Int. J. Hydrog. Energy 32(17) (2007) 4489-4502.
[16] E.G. Karvelas, D.G. Koubogiannis, A. Hatziapostolou, I.E. Sarris, The effect of anode bed geometry on the hydraulic behaviour of PEM fuel cells, Renew. Energy 93(2016) 269-279.
[17] D.N. Ozen, B. Timurkutluk, K. Altinisik, Effects of operation temperature and reactant gas humidity levels on performance of PEM fuel cells, Renew. Sust. Energ. Rev. 59(2016) 1298-1306.
[18] V. Velisala, G. Naga, G.N. Srinivasulu, Numerical simulation and experimental comparison of single, double and triple serpentine flow channel configuration on performance of a PEM fuel cell, Arab. J. Sci. Eng. 43(3) (2018) 1225-1234.
[19] M. Ziauddin, O. Genc, S. Toros, ScienceDirect Numerical optimization of channel to land width ratio for PEM fuel cell, Int. J. Hydrog. Energy 43(23) (2018) 10798-10809.
[20] A. Shaik, P.V. Suresh, Detailed analysis of polymer electrolyte membrane fuel cell with enhanced cross-flow split serpentine flow field design, Int. J. Energy Res. 43(7) (2019) 2806-2820.
[21] Z.F. Pan, L. An, T.S. Zhao, Z.K. Tang, Advances and challenges in alkaline anion exchange membrane fuel cells, Prog. Energy Combust. Sci. 66(2018) 141-175.
[22] M.A.H.E.H. Majlan, D. Rohendi, W.R.W. Daud, T. Husaini, Electrode for proton exchange membrane fuel cells:A review, Renew. Sust. Energ. Rev. 89(2018) 117-134.
[23] B. Chi, S.Y. Hou, G.Z. Liu, Y.J. Deng, J.H. Zeng, H.Y. Song, S.J. Liao, J.W. Ren, Turning hydrophobic-hydrophilic balance of cathode catalyst layer to improve cell performance of proton exchange membrane fuel cell (PEMFC) by mixing polytetrafluoroethylene (PTFE), Electrochim. Acta 277(2018) 110-115.
[24] M. Ziauddin, B. Timurkutluk, Transport phenomena of convergent and divergent serpentine flow fields for PEMFC, Energy 161(2018) 104-117.
[25] A. Kazim, P. Forges, H.T. Liu, Effects of cathode operating conditions on performance of a PEM fuel cell with interdigitated flow fields, Int. J. Energy Res. 27(4) (2003) 401-414.
[26] A.K.P. Hadi Heidary, M.J. Kermani, S.G. Advani, Experimental investigation of in-line and staggered blockages in parallel flowfield channels of PEM fuel cells, Int. J. Hydrog. Energy 41(6885-6893) (2016) 1-9.