Design and optimization of an integrated process for the purification of propylene oxide and the separation of propylene glycol by-product

doi:10.1016/j.cjche.2021.04.012

Abstract

Abstract: It is difficult to separate the methanol and hydrocarbons in the propylene oxide (PO) purification process due to their forming azeotrope. As for this, a novel PO separation process, in that the deionized water is employed as extractant and 1,2-propylene glycol (MPG) that is formed from the PO hydrolysis reaction is recovered, is presented in this work. The salient feature of this process is that both the non-catalyzed reactions of PO hydrolysis to form MPG and dipropylene glycol (DPG) are simultaneously considered and MPG by-product with high purity is obtained in virtue of the deionized water as reflux liquid and side take-off in MPG column. In addition, the ionic liquid (IL) extractant is screened through the conductor-like screening model for segment activity coefficient (COSMO-SAC) and the comparisons of separation efficiency between the IL and normal octane (nC₈) extractant for the separation of PO and 2-methylpentane are made. With the non-random two-liquid (NRTL) thermodynamic model, the simulation and optimization design for the full flow sheet are performed and the effects of the key operation parameters such as solvent ratio, theoretical stages, feeding stage etc. on separation efficiency are detailedly discussed. The results show that the mass purity and the mass yield of PO can be up to 99.99% and 99.0%, and the condenser duty, reboiler duty and PO loss in the process with IL extractant can be decreased by 69.66%, 30.21% and 78.86% compared to ones with nC₈. The total annual cost (TAC) calculation also suggests that the TAC would be significantly reduced if using IL in replace of nC₈ for the investigated process. The presented results would provide a useful guide for improving the quality of PO product and the economic efficiency of industrial plant.

Key words: Propylene oxide purification, Ionic liquids, Separation, Extractive distillation, Hydrolysis, 1,2-propylene glycol

摘要： It is difficult to separate the methanol and hydrocarbons in the propylene oxide (PO) purification process due to their forming azeotrope. As for this, a novel PO separation process, in that the deionized water is employed as extractant and 1,2-propylene glycol (MPG) that is formed from the PO hydrolysis reaction is recovered, is presented in this work. The salient feature of this process is that both the non-catalyzed reactions of PO hydrolysis to form MPG and dipropylene glycol (DPG) are simultaneously considered and MPG by-product with high purity is obtained in virtue of the deionized water as reflux liquid and side take-off in MPG column. In addition, the ionic liquid (IL) extractant is screened through the conductor-like screening model for segment activity coefficient (COSMO-SAC) and the comparisons of separation efficiency between the IL and normal octane (nC₈) extractant for the separation of PO and 2-methylpentane are made. With the non-random two-liquid (NRTL) thermodynamic model, the simulation and optimization design for the full flow sheet are performed and the effects of the key operation parameters such as solvent ratio, theoretical stages, feeding stage etc. on separation efficiency are detailedly discussed. The results show that the mass purity and the mass yield of PO can be up to 99.99% and 99.0%, and the condenser duty, reboiler duty and PO loss in the process with IL extractant can be decreased by 69.66%, 30.21% and 78.86% compared to ones with nC₈. The total annual cost (TAC) calculation also suggests that the TAC would be significantly reduced if using IL in replace of nC₈ for the investigated process. The presented results would provide a useful guide for improving the quality of PO product and the economic efficiency of industrial plant.

关键词: Propylene oxide purification, Ionic liquids, Separation, Extractive distillation, Hydrolysis, 1,2-propylene glycol

Song Hu, Jinlong Li, Qihua Wang, Weisheng Yang. Design and optimization of an integrated process for the purification of propylene oxide and the separation of propylene glycol by-product[J]. Chinese Journal of Chemical Engineering, 2022, 45(5): 111-120.

References

[1] H. Baer, M. Bergamo, A. Forlin, L.H. Pottenger, J. Lindner,Propylene oxide,In:Ullmann's Encyclopedia of Industrial Chemistry, Wiley-VCH Verlag GmbH &Co. KGaA,Weinheim, 2012
[2] T.A. Nijhuis, M. Makkee, J.A. Moulijn, B.M. Weckhuysen, The production of propene oxide:Catalytic processes and recent developments, Ind. Eng. Chem. Res. 45 (10) (2006) 3447-3459
[3] S.J. Khatib, S.T. Oyama, Direct oxidation of propylene to propylene oxide with molecular oxygen:A review, Catal. Rev. 57 (3) (2015) 306-344
[4] L. H. Horsley, Azeotropic Data-III. Advances in Chemistry Series, American Chemical Society, Washington, D.C., 1973.
[5] W.G. Gu, W.S. Yang, H. Li, S. Hu, Refining method of propylene epoxide, China Pat., 107286119A (2017). (in Chinese)
[6] S. Hu, W.S. Yang, Method for purifying epoxypropane (PO), China Pat., 105566252A (2014). (in Chinese)
[7] Z.M. Wang, X. Wang, C. Wang, M.W. Zhao, L.L. Liu, Separation and purification method of propylene epoxide, China Pat., 106496163A (2017). (in Chinese)
[8] H. Willi, H. Thomas, W. Wolfgang, T. Georg, Process for the purification of crude propene oxide, China Pat., 101298443A (2008). (in Chinese)
[9] T.T. Shih, Lower alkylene oxide purification, U.S. Pat., 5133839 (1991).
[10] S. Hu, J.L. Li, M.J. Li, W.S. Yang, Extractive refining process for production of propylene oxide with high purification, CIESC J. 70 (2) (2019) 670-677 (in Chinese).
[11] E.T. Marquis, G.P. Speranza, Y.E. Sheu, W.K. Culbreth, III, D.G. Pattratz, Propylene oxide purification by extractive distillation, U.S. Pat., 5116466 (1992).
[12] E.T. Marquis, G.P. Speranza, Y.E. Sheu, W.K. Culbreth, III, D.G. Pattratz, Purification of propylene oxide by extractive distillation, U.S. Pat., 5139622 (1992).
[13] W.A. Smith, M.A. Mueller, Extractive distillation of propylene oxide using propanol, U.S. Pat., 5620568 (1997).
[14] W.P. Nelson, W.A. Smith, Purification of propylene oxide by cosolvent extractive distillation, U.S. Pat., 5340466 (1992).
[15] Y.C. Li, Y.X. Li, X. Feng, Y.M. Chai, C.G. Liu, Adsorptive removal of acetaldehyde from propylene oxide produced by the hydrogen peroxide to propylene oxide process, ACS Omega 3 (11) (2018) 15272-15280
[16] J.U. Schmidt, A.U. Garcia, Separation of propylene oxide from other hydrocarbons, U.S. Pat.3843488 (1967).
[17] J.J.C. Jubin, Separation of propylene oxide from other hydrocarbons, U.S. Pat., 3464897 (1969).
[18] J.P. Schmidt, J.A. Garcia, Purification of propylene oxide by distillation, U.S. Pat., 3909366 (1972).
[19] W.A. Smith, R.A. Meyer, E.T. Nguyen, Purification of propylene oxide by liquid extraction, U.S. Pat., 5127997 (1992).
[20] F.L. Fang, Q.Q. Liu, H.Y. Song, X.Q. Yuan, Kinetics of epoxidation of propylene catalyzed by titanium silicate, Chem. React. Eng. Technol. 24 (1) (2008) 77-81. (in Chinese)
[21] S. Wang, S.T. Lin, J. Chang, W.A. Goddard, S.I. Sandler, Application of the COSMO-SAC-BP solvation model to predictions of normal boiling temperatures for environmentally significant substances, Ind. Eng. Chem. Res. 45 (16) (2006) 5426-5434
[22] C.M. Hsieh, S.I. Sandler, S.T. Lin, Improvements of COSMO-SAC for vapor-liquid and liquid-liquid equilibrium predictions, Fluid Phase Equilib.297 (1) (2010) 90-97
[23] J.L. Li, X.Q. Yang, K.X. Chen, Y.L. Zheng, C.J. Peng, H.L. Liu, Sifting ionic liquids as additives for separation of acetonitrile and water azeotropic mixture using the COSMO-RS method, Ind. Eng. Chem. Res. 51(27) (2012) 9376-9385
[24] T.T. Li, Q. Yang, H.R. Ding, J.L. Li, C.J. Peng, H.L. Liu, Amino acid based ionic liquids as additives for the separation of an acetonitrile and water azeotropic mixture:COSMO-RS prediction and experimental verification, Ind. Eng. Chem. Res. 54 (48) (2015) 12143-12149
[25] J.L. Li, T.T. Li, C.J. Peng, H.L. Liu, Extractive distillation with ionic liquid entrainers for the separation of acetonitrile and water, Ind. Eng. Chem. Res. 58 (14) (2019) 5602-5612
[26] S. Hu, J.L. Li, W.S. Yang, Propylene oxide offgas recovery and purification process with methanol solvent, CIESC J. 71 (4) (2020) 1657-1665. (in Chinese)
[27] H. Renon, J.M. Prausnitz, Local compositions in thermodynamic excess functions for liquid mixtures, AIChE J., 14 (1) (1968) 135-144
[28] J.N. Wickert, W.S. Tamplin, R.L. Shank, Phase equilibria in the system propylene oxide-water, Chem. Eng. Prog. Symp. Ser.48(1) (1952) 92-96
[29] M. Muehlenbruch, G.Z. Figurski, The vapor-liquid equilibrium of the binary systems acetaldehyde-propylene oxide, acetaldehyde-methylformate, and propylene oxide-propan-2-ol at 101.325 kPa, Phys. CHem. (Leipzig)270 (1970) 305
[30] N.I. Gleperin, V.L. Pebalk, V. G. Varfolomeev, O.V. Smirnova, O. G. Denisov, Liquid-vapor equilibrium in binary systems, Zh. Prikl. Khim.49 (1976) 880-881
[31] R. Vilcu, Z. Cenuse, Liquid-vapor equilibria under isobaric conditions in the propene oxide-acetaldehyde binary system, Rev. Chim. (Bucharest)37 (1986) 282-284
[32] S. Horstmann, M. Wilken, K. Fischer, J. Gmehling, Isothermal vapor-liquid equilibrium and excess enthalpy data for the binary systems propylene oxide + 2-methylpentane and difluoromethane (R32) + pentafluoroethane (R125), J. Chem. Eng. Data49 (2004) 1504-1507
[33] S. Raeissi, L.J. Florusse, C.J. Peters, Vapor-liquid equilibria of binary mixtures of propylene oxide with either ethyl benzene, 2-methylpentane, or 2-methyl-1-pentene, Fluid Phase Equilib.352 (2013) 97-99
[34] V.N. Vostrikova, T.V. Komarova, V.M. Platonov, L.V. Morozova, T.P. Moiseeva, M.N. Saenko, M.E. Aerov, Liquid-vapor equilibrium in binary systems containing propene oxide, Zh. Prikl. Khim.47 (1974) 568-571
[35] K. Dong, X.M. Liu, H.F. Dong, X.P. Zhang, S.J. Zhang, Multiscale studies on ionic liquids, Chem. Rev. 117 (10) (2017) 6636-6695
[36] National standards of the People's Republic of China, Propylene oxide for industrial use, GB/T 14491-2015 (2015).
[37] J.O. Valderrama, P.A. Robles, Critical properties, normal boiling temperatures, and acentric factors of fifty ionic liquids, Ind. Eng. Chem. Res. 46 (4) (2007) 1338-1344
[38] J.O. Valderrama, P.A. Robles, Reply to "comment on ‘critical properties, normal boiling temperature, and acentric factor of fifty ionic liquids’", Ind. Eng. Chem. Res. 46 (2007) 6063-6064
[39] J.O. Valderrama, R.E. Rojas, Critical properties of ionic liquids. revisited, Ind. Eng. Chem. Res. 48 (14) (2009) 6890-6900
[40] J.O. Valderrama, K. Zarricueta, A simple and generalized model for predicting the density of ionic liquids, Fluid Phase Equilib.275 (2) (2009) 145-151
[41] J.O. Valderrama, R.E. Rojas, Mass connectivity index, a new molecular parameter for the estimation of ionic liquid properties, Fluid Phase Equilib.297 (1) (2010) 107-112
[42] J.M. Douglas, Conceptual Design of Chemical Processes, McGraw-Hill, New York, 1988
[43] B.J. Zhang, W.S. Yang, S. Hu, Y.Z. Liang, Q.L. Chen, A reactive distillation process with a sidedraw stream to enhance the production of isopropyl acetate, Chem. Eng. Process.:Process Intensif. 70 (2013) 117-130