Please wait a minute...
SCI和EI收录∣中国化工学会会刊
本期目录
1998年 第6卷 第2期 刊出日期:1998-06-28
    Volume 6
    Filmwise Condensation Heat Transfer Enhancement with Dropwise and Filmwise Coexisting Condensation Surfaces
    马学虎, 王补宣, 徐敦颀, 林纪方
    . 1998, 6(2):  95-102.  doi:
    摘要 ( )   PDF (1966KB) ( )  
    参考文献 | 相关文章 | 多维度评价
    Six surfaces were prepared with different surface division patternsfor the experimental investigation of steam condensation
    heat transfer characteristics for dropwise and filmwise coexisting (DFC) condensation surfacesunder atmospheric pressure.
    Dropwise condensation (DWC) was promoted withan ultrathin polytetrafluoroethylene (PTFE) film,which was prepared by
    thedynamic ion-beam mixed implantation (DIMI) method. The results showed thatthe condensation phenomena at the
    intersection between the dropwise and filmwisecondensation regions were quite different for different relative positions
    ofthe dropwise and filmwise condensation regions.The experimental results revealedthat the condensation heat transfer
    characteristics were highly influenced bythe surface division number and the relative area ratio of the dropwise andfilmwise
    condensation regions.The impact of these findings on heat transferenhancement mechanism for condensation heat transfer is
    discussed in detail.
    Analysis of Operating Variables in the Catalytic Purification of Butene-1 in a Trickle Bed
    Sergio P.Bressa, Nestor O.Ardiaca, Osvaldo M.Martinez, Guillermo F.Barreto
    . 1998, 6(2):  103-115.  doi:
    摘要 ( )   PDF (2880KB) ( )  
    参考文献 | 相关文章 | 多维度评价
    A mathematical model for analyzing and simulating selective hydrogenation of butyne-1 and 1,3-bu-tadiene in industrial
    trickle bed reactors operated to obtain high purity butene-1 is presented in this work.From the analysis of typical operating
    conditions,only the relevant phenomena are finally retained in the model formulation.The model is then employed to analyze
    the effect of operating variables and catalyst selectivity in process performance.In particular,the search for the minimum
    hydrogen flow rate necessary to fulfil butene-1 purity specifications is undertaken.
    Diffusion Characteristics in Microcapsules
    姚善泾, 赵万纪
    . 1998, 6(2):  116-123.  doi:
    摘要 ( )   PDF (1866KB) ( )  
    相关文章 | 多维度评价
    An equation of diffusion for microcapsules (hollow sphere) was developed, employing the mathematical model for the diffusion characteristics of solid sphere. In the proposed equation, a combination diffusion coefficient was introduced as a substitute for the diffusion coefficient in the solid sphere mathematical model and expressed as a function of the diffusion coefficient inside solution of hollow sphere, as well as in the polymer membrane. With this modified model, the diffusion coefficients of glucose in NaCS (sodium cellulose sulfate)- PDADMAC (Poly-diallyl-dimethyl-ammonium chloride) membrane and in Ca-alginate gel membrane were determined. The diffusion coefficient in NaCS-PDADMAC membrane was found to be 2.12×10-11 m2·s-1 and that in Ca-alginate membrane 2.62×10-10m2·s-1.
    Extraction of Lithium from Brine Containing High Concentration of Magnesium by Tri-n-Butyl Phosphate Dissolved in Kerosene
    缑泽明, 朱慎林
    . 1998, 6(2):  124-129.  doi:
    摘要 ( )   PDF (1315KB) ( )  
    参考文献 | 相关文章 | 多维度评价
    Tri-n-butyl phosphate (TBP)dissolved in kerosene was chosen as extractant for lithium from a model brine having high
    magnesium-to-lithium ratio and ferric chloride was added to the system.The influences of contact time, concentration of the
    extractant, concentrations of some salts (Mg2+, Na+, K+)in the solution, acidity of hydrochloric acid and extraction
    temperature on the extraction of lithium with TBP-kerosene system were studied.The suitable extraction conditions were found
    to be :contact time not any less than 20 min;at 20—25℃;[Fe3+]/[Li+]about 1.5—2.0;TBP concentration 50%—70%;
    [MgCl2] exceeding 3 mol*L-1;pH about 2;while most sodium and potassium salts in the aqueous phase should be removed before
    the extraction.
    Influence of Deformation-Induced Martensite on Stress Corrosion Cracking of AISI 321 Stainless Steel
    许淳淳, 徐瑞芬, 欧阳维真, 姜宝文, 吴永炘
    . 1998, 6(2):  130-137.  doi:
    摘要 ( )   PDF (2138KB) ( )  
    参考文献 | 相关文章 | 多维度评价
    Specimens of AISI 321 stainless steel (0Cr18Ni9Ti) of various martensite contents were prepared by the low temperature(-70℃
    ) elongation method.X-ray diffraction (XRD) and transmission electron micrograph (TEM) techniques were used to study the
    phase transition process and its structure.The relationship between deformation-induced martensite and stress corrosion
    cracking (SCC) susceptibility of the steel in 42% (boiling)MgCl2 solution was investigated using the constant load SCC test
    with the normalized threshold values.The results reveal that when the α′-martensite content is less than 5% and also in
    the range of 15%—24%, the SCC susceptibility of this material decreases with the increase of α′-martensite
    content.However, when the α′-martensite content is in the rang of 5%—15% and more than 24%, the SCC susceptibility of
    this material increases with the increase of the α′-martensite content.The SCC fracture surface of the specimens exhibits a
    stepped fracture surface and transgranular stress corrosion fracture surface morphology.
    Multiplicity in Continuous Adiabatic MSMPR Reactive Precipitators
    尹秋响
    . 1998, 6(2):  138-148.  doi:
    摘要 ( )   PDF (2210KB) ( )  
    参考文献 | 相关文章 | 多维度评价
    The possibility of both concentration and temperature multiplicities has been studied for the case of a continuous adiabatic
    mixed suspension mixed product removal (MSMPR) reactive precipitator. A process involving homogeneous chemical reaction in
    first order reaction kinetics with respect to each of the reactive components and subsequent crystallization described by
    conventional power law growth and power law magma dependent nucleation models is considered. The temperature dependency of
    each of these kinetics is described by Arrhenius relations. Parameter regions are determined in which multiple steady states
    exist. The linear stability of these steady states is analyzed by using the Routh criterion approach.
    Intelligent Optimized Control System for Solvent Dewaxing Device
    熊刚, 许晓鸣, 孙优贤
    . 1998, 6(2):  149-158.  doi:
    摘要 ( )   PDF (1976KB) ( )  
    参考文献 | 相关文章 | 多维度评价
    Methods for promoting product and reducing energy consumption in a solvent dewaxing device are put forward. Then, the authors
    mainly discuss about adaptive database, mathematical modeling, mathematical op-timized control algorithm, expert optimized
    control system and intelligent alarming system etc. At last, hardware and software of the intelligent optimized control
    system are introduced. Field test is finally chosen for this study and proved that the intelligent optimized control system
    is effective.
    RESEARCH NOTES
    Prediction of Diffusion Coefficients of Liquid and Solid Solutes in Supercritical Solvents
    何潮洪
    . 1998, 6(2):  159-165.  doi:
    摘要 ( )   PDF (1354KB) ( )  
    参考文献 | 相关文章 | 多维度评价
    The Drying of Pyridine Hydrobromide
    Rene D.Peralta Rodriguez, Raul G.Lopez Campos, Jaime Wisniak, Jacinto G.Rodriguez Gomez, Silvia Torres Rincon, M.Esther Trevio Martinez
    . 1998, 6(2):  166-170.  doi:
    摘要 ( )   PDF (1127KB) ( )  
    参考文献 | 相关文章 | 多维度评价
    Determination of the Structure of Polyacrylamide/Aluminum Citrate Colloidal Dispersion Gel System
    彭勃, 李明远, 纪淑玲, 吴肇亮
    . 1998, 6(2):  171-173.  doi:
    摘要 ( )   PDF (930KB) ( )  
    参考文献 | 相关文章 | 多维度评价
    Determination of Thermodynamic Parameters of Some Fluorochlorohydrocarbons in Acetone by Gas Chromatography at Low
    Temperature and Pressurization
    王丽华
    . 1998, 6(2):  174-182.  doi:
    摘要 ( )   PDF (1742KB) ( )  
    参考文献 | 相关文章 | 多维度评价
    Isobaric Vapor-Liquid Equilibria for 2-Methylphenol-2,6-Dimethylphenol-2,4,6-Trimethylphenol Ternary System
    叶汝强, 夏明思, 虞大红, 刘洪来, 胡英
    . 1998, 6(2):  183-188.  doi:
    摘要 ( )   PDF (1181KB) ( )  
    参考文献 | 相关文章 | 多维度评价