SCI和EI收录∣中国化工学会会刊

中国化学工程学报 ›› 2020, Vol. 28 ›› Issue (9): 2447-2456.DOI: 10.1016/j.cjche.2020.04.004

• Energy, Resources and Environmental Technology • 上一篇    下一篇

A novel method for the management of sulfone-rich waste produced in the oxidative desulfurization (ODS) process

Sobhan Farahani, Mohammad Amin Sobati   

  1. School of Chemical Engineering, Iran University of Science and Technology (IUST), Tehran 16765-163, Iran
  • 收稿日期:2019-12-04 修回日期:2020-03-25 出版日期:2020-09-28 发布日期:2020-10-21
  • 通讯作者: Mohammad Amin Sobati
  • 基金资助:
    The authors would like to acknowledge the supports provided by National Iranian Oil Engineering and Construction Company (NIOEC).

A novel method for the management of sulfone-rich waste produced in the oxidative desulfurization (ODS) process

Sobhan Farahani, Mohammad Amin Sobati   

  1. School of Chemical Engineering, Iran University of Science and Technology (IUST), Tehran 16765-163, Iran
  • Received:2019-12-04 Revised:2020-03-25 Online:2020-09-28 Published:2020-10-21
  • Contact: Mohammad Amin Sobati
  • Supported by:
    The authors would like to acknowledge the supports provided by National Iranian Oil Engineering and Construction Company (NIOEC).

摘要: The oxidative desulfurization (ODS) process is one of the new desulfurization processes for the production of clean fuels. Despite the benefits of the ODS process, this process faces several important challenges. One of the most important challenges of this process is the management of a waste which is rich of sulfone compounds. In the present study, a new strategy which is the addition of waste to the bitumen with other solid waste such as high density polyethylene (HDPE) waste has been investigated. The experimental design method was applied to investigate the effect of addition of the sulfone and HDPE wastes to the properties of the bitumen blends including degree of penetration, softening point, and mass loss. It was found that the sulfone waste can be added to the bitumen as a softener. The results showed that several grades of bitumen including 50/60, 60/70, 85/100 can be produced through the addition of sulfone waste along with the HDPE waste to the base 60/70 bitumen. In general, the application of simple processes such as mixing the wastes with the bitumen can reduce the cost of waste management, considerably.

关键词: OXIDATIVE desulfurization, Waste management, Sulfone waste, Bitumen, Experimental design, High density polyethylene (HDPE) waste

Abstract: The oxidative desulfurization (ODS) process is one of the new desulfurization processes for the production of clean fuels. Despite the benefits of the ODS process, this process faces several important challenges. One of the most important challenges of this process is the management of a waste which is rich of sulfone compounds. In the present study, a new strategy which is the addition of waste to the bitumen with other solid waste such as high density polyethylene (HDPE) waste has been investigated. The experimental design method was applied to investigate the effect of addition of the sulfone and HDPE wastes to the properties of the bitumen blends including degree of penetration, softening point, and mass loss. It was found that the sulfone waste can be added to the bitumen as a softener. The results showed that several grades of bitumen including 50/60, 60/70, 85/100 can be produced through the addition of sulfone waste along with the HDPE waste to the base 60/70 bitumen. In general, the application of simple processes such as mixing the wastes with the bitumen can reduce the cost of waste management, considerably.

Key words: OXIDATIVE desulfurization, Waste management, Sulfone waste, Bitumen, Experimental design, High density polyethylene (HDPE) waste