SCI和EI收录∣中国化工学会会刊

中国化学工程学报 ›› 2019, Vol. 27 ›› Issue (10): 2304-2312.DOI: 10.1016/j.cjche.2019.03.009

• Fluid Dynamics and Transport Phenomena • 上一篇    下一篇

Numerical and experimental analyses of a stirred vessel for a large volumetric flow rate of sparged air

Andrej Bombač, Jernej Pirnar   

  1. Laboratory for Fluid Dynamics and Thermodynamics, Faculty of Mechanical Engineering, University of Ljubljana, Aškerčeva 6, 1000 Ljubljana, Slovenia
  • 收稿日期:2018-09-20 修回日期:2019-01-24 出版日期:2019-10-28 发布日期:2020-01-17
  • 通讯作者: Andrej Bombač

Numerical and experimental analyses of a stirred vessel for a large volumetric flow rate of sparged air

Andrej Bombač, Jernej Pirnar   

  1. Laboratory for Fluid Dynamics and Thermodynamics, Faculty of Mechanical Engineering, University of Ljubljana, Aškerčeva 6, 1000 Ljubljana, Slovenia
  • Received:2018-09-20 Revised:2019-01-24 Online:2019-10-28 Published:2020-01-17
  • Contact: Andrej Bombač

摘要: Computational fluid dynamics (CFD) and experimental analyses of some of the basic characteristics of air sparging in a tall stirred vessel equipped with a three-stage impeller are presented. The impeller was assembled from a radial ABT impeller as the lower, a turbine 6PBT45 as the middle and an axial Scaba-type 3SHP1 impeller as the upper. All the impellers were of the same diameter, i.e., 225 mm, while the vessel diameter was 450 mm. The impeller's rotational speed was 178 r·min-1. The aeration regime was established with an air volumetric flow rate of 28.3 m3·h-1. To the best of our knowledge, this study is the first to consider the very high gassing rate by means of CFD in a tank stirred by three-stage axial/radial impellers.
The numerical simulation was performed using the ANSYS Fluent (R17.2, 2016) code for solving the governing equations of fluid dynamics in single- and multi-phase systems. While discussing the bubble size distribution, a discrete population balance model (PBM) was used. Adopting CFD, the stirring power and the total void fraction (the total gas holdup) were calculated. The results were in good agreement with the measured values using a laboratory experimental device.

关键词: Mixing, Stirred vessel, Aeration, Multiple stirrer, High gassing rate, Local void fraction

Abstract: Computational fluid dynamics (CFD) and experimental analyses of some of the basic characteristics of air sparging in a tall stirred vessel equipped with a three-stage impeller are presented. The impeller was assembled from a radial ABT impeller as the lower, a turbine 6PBT45 as the middle and an axial Scaba-type 3SHP1 impeller as the upper. All the impellers were of the same diameter, i.e., 225 mm, while the vessel diameter was 450 mm. The impeller's rotational speed was 178 r·min-1. The aeration regime was established with an air volumetric flow rate of 28.3 m3·h-1. To the best of our knowledge, this study is the first to consider the very high gassing rate by means of CFD in a tank stirred by three-stage axial/radial impellers.
The numerical simulation was performed using the ANSYS Fluent (R17.2, 2016) code for solving the governing equations of fluid dynamics in single- and multi-phase systems. While discussing the bubble size distribution, a discrete population balance model (PBM) was used. Adopting CFD, the stirring power and the total void fraction (the total gas holdup) were calculated. The results were in good agreement with the measured values using a laboratory experimental device.

Key words: Mixing, Stirred vessel, Aeration, Multiple stirrer, High gassing rate, Local void fraction