SCI和EI收录∣中国化工学会会刊

中国化学工程学报 ›› 2019, Vol. 27 ›› Issue (9): 2089-2098.DOI: 10.1016/j.cjche.2019.02.008

• Special Issue on Natural Gas Hydrate • 上一篇    下一篇

Dissociation characteristics of methane hydrate using depressurization combined with thermal stimulation

Mingjun Yang, Zhanquan Ma, Yi Gao, Lanlan Jiang   

  1. Key Laboratory of Ocean Energy Utilization and Energy Conservation of Ministry of Education, Dalian University of Technology, Dalian 116024, China
  • 收稿日期:2018-11-30 修回日期:2019-01-20 出版日期:2019-09-28 发布日期:2019-12-04
  • 通讯作者: Lanlan Jiang
  • 基金资助:
    Supported by the National Natural Science Foundation of China (51436003, 51822603, 51576025), the National Key Research and Development Program of China (2017YFC0307303, 2016YFC0304001), the Fok Ying Tong Education Foundation for Young Teachers in the Higher Education Institutions of China (161050) and the Fundamental Research Funds for the Central Universities of China (DUT18ZD403).

Dissociation characteristics of methane hydrate using depressurization combined with thermal stimulation

Mingjun Yang, Zhanquan Ma, Yi Gao, Lanlan Jiang   

  1. Key Laboratory of Ocean Energy Utilization and Energy Conservation of Ministry of Education, Dalian University of Technology, Dalian 116024, China
  • Received:2018-11-30 Revised:2019-01-20 Online:2019-09-28 Published:2019-12-04
  • Contact: Lanlan Jiang
  • Supported by:
    Supported by the National Natural Science Foundation of China (51436003, 51822603, 51576025), the National Key Research and Development Program of China (2017YFC0307303, 2016YFC0304001), the Fok Ying Tong Education Foundation for Young Teachers in the Higher Education Institutions of China (161050) and the Fundamental Research Funds for the Central Universities of China (DUT18ZD403).

摘要: Methane hydrate is considered as a potential energy source in the future due to its abundant reserves and high energy density. To investigate the influence of initial hydrate saturation, production pressure, and the temperature of thermal stimulation on gas production rate and cumulative gas production percentage, we conducted the methane hydrate dissociation experiments using depressurization, thermal stimulation and a combination of two methods in this study. It is found that when the gas production pressures are the same, the higher the hydrate initial saturation, the greater change in hydrate reservoir temperature. Therefore, it is easier to appear the phenomenon of icing and hydrate reformation when the hydrate saturation is higher. For example, the reservoir temperature dropped to below zero in depressurization process when the hydrate saturation was about 37%. However, the same phenomenon didn't appear as the saturation was about 12%. This may be due to more free gas in the reservoir with hydrate saturated of 37%. We also find that the temperature variation of reservoir can be reduced effectively by combination of depressurization and thermal stimulation method. And the average gas production rate is highest with combined method in the experiments. When the pressure of gas production is 2 MPa, compared with depressurization, the average of gas production can increase 54% when the combined method is used. The efficiency of gas production is very low when thermal stimulation was used alone. When the temperature of thermal stimulation is 11℃, the average rate of gas production in the experiment of thermal stimulation is less than 1/3 of that in the experiment of the combined method.

关键词: Methane hydrate, Depressurization, Thermal stimulation, Dissociation characteristics

Abstract: Methane hydrate is considered as a potential energy source in the future due to its abundant reserves and high energy density. To investigate the influence of initial hydrate saturation, production pressure, and the temperature of thermal stimulation on gas production rate and cumulative gas production percentage, we conducted the methane hydrate dissociation experiments using depressurization, thermal stimulation and a combination of two methods in this study. It is found that when the gas production pressures are the same, the higher the hydrate initial saturation, the greater change in hydrate reservoir temperature. Therefore, it is easier to appear the phenomenon of icing and hydrate reformation when the hydrate saturation is higher. For example, the reservoir temperature dropped to below zero in depressurization process when the hydrate saturation was about 37%. However, the same phenomenon didn't appear as the saturation was about 12%. This may be due to more free gas in the reservoir with hydrate saturated of 37%. We also find that the temperature variation of reservoir can be reduced effectively by combination of depressurization and thermal stimulation method. And the average gas production rate is highest with combined method in the experiments. When the pressure of gas production is 2 MPa, compared with depressurization, the average of gas production can increase 54% when the combined method is used. The efficiency of gas production is very low when thermal stimulation was used alone. When the temperature of thermal stimulation is 11℃, the average rate of gas production in the experiment of thermal stimulation is less than 1/3 of that in the experiment of the combined method.

Key words: Methane hydrate, Depressurization, Thermal stimulation, Dissociation characteristics