Numerical simulation of fixed bed reactor for oxidative coupling of methane over monolithic catalyst

doi:10.1016/j.cjche.2015.07.025

摘要/Abstract

摘要： A three-dimensional geometric modelwas set up for the oxidative coupling of methane (OCM) fixed bed reactor loaded with Na₃PO₄-Mn/SiO₂/cordierite monolithic catalyst, and an improved Stansch kinetic model was established to calculate the OCMreactions using the computational fluid dynamicsmethod and Fluent software. The simulation conditions were completely the same with the experimental conditions that the volume velocity of the reactant is 80 ml·min^-1 under standard state, the CH₄/O₂ ratio is 3 and the temperature and pressure is 800 ℃ and 1 atm, respectively. The contour of the characteristic parameters in the catalyst bed was analyzed, such as the species mass fractions, temperature, the heat flux on side wall surface, pressure, fluid density and velocity. The results showed that the calculated valuesmatchedwell with the experimental values on the conversion of CH₄ and the selectivity of products (C₂H₆, C₂H₄, CO,CO₂ and H₂) in the reactor outlet with an error range of ±4%. The mass fractions of CH₄ and O₂ decreased from 0.600 and 0.400 at the catalyst bed inlet to 0.445 and 0.120 at the outlet, where the mass fractions of C₂H₆, C₂H₄, CO and CO₂ were 0.0245, 0.0460, 0.0537 and 0.116, respectively. Due to the existence of laminar boundary layer, the mass fraction contours of each species bent upwards in the vicinity of the boundary layer. The volume of OCM reaction was changing with the proceeding of reaction, and the total moles of products were greater than reactants. The flow field in the catalyst bed maintained constant temperature and pressure. The fluid density decreased gradually from 2.28 kg·m^-3 at the inlet of the catalyst bed to 2.18 kg·m^-3 at the outlet of the catalyst bed, while the average velocity magnitude increased from 0.108 m·s^-1 to 0.120 m·s^-1.

关键词: Numerical simulation, Fixed bed reactor, Computational fluid dynamics, Oxidative coupling of methane, Monolithic catalyst

Abstract: A three-dimensional geometric modelwas set up for the oxidative coupling of methane (OCM) fixed bed reactor loaded with Na₃PO₄-Mn/SiO₂/cordierite monolithic catalyst, and an improved Stansch kinetic model was established to calculate the OCMreactions using the computational fluid dynamicsmethod and Fluent software. The simulation conditions were completely the same with the experimental conditions that the volume velocity of the reactant is 80 ml·min^-1 under standard state, the CH₄/O₂ ratio is 3 and the temperature and pressure is 800 ℃ and 1 atm, respectively. The contour of the characteristic parameters in the catalyst bed was analyzed, such as the species mass fractions, temperature, the heat flux on side wall surface, pressure, fluid density and velocity. The results showed that the calculated valuesmatchedwell with the experimental values on the conversion of CH₄ and the selectivity of products (C₂H₆, C₂H₄, CO,CO₂ and H₂) in the reactor outlet with an error range of ±4%. The mass fractions of CH₄ and O₂ decreased from 0.600 and 0.400 at the catalyst bed inlet to 0.445 and 0.120 at the outlet, where the mass fractions of C₂H₆, C₂H₄, CO and CO₂ were 0.0245, 0.0460, 0.0537 and 0.116, respectively. Due to the existence of laminar boundary layer, the mass fraction contours of each species bent upwards in the vicinity of the boundary layer. The volume of OCM reaction was changing with the proceeding of reaction, and the total moles of products were greater than reactants. The flow field in the catalyst bed maintained constant temperature and pressure. The fluid density decreased gradually from 2.28 kg·m^-3 at the inlet of the catalyst bed to 2.18 kg·m^-3 at the outlet of the catalyst bed, while the average velocity magnitude increased from 0.108 m·s^-1 to 0.120 m·s^-1.

Key words: Numerical simulation, Fixed bed reactor, Computational fluid dynamics, Oxidative coupling of methane, Monolithic catalyst

Zhao Zhang, Ziqi Guo, Shengfu Ji. Numerical simulation of fixed bed reactor for oxidative coupling of methane over monolithic catalyst[J]. Chinese Journal of Chemical Engineering, 2015, 23(10): 1627-1633.

Zhao Zhang, Ziqi Guo, Shengfu Ji. Numerical simulation of fixed bed reactor for oxidative coupling of methane over monolithic catalyst[J]. Chin.J.Chem.Eng., 2015, 23(10): 1627-1633.

参考文献

[1] J.H. Lunsford, Catalytic conversion ofmethane tomore useful chemicals and fuels: A challenge for the 21st century, Catal. Today 63 (2-4) (2000) 165-174.

[2] H.D. Gesser, N.R. Hunter, A review of C-1 conversion chemistry, Catal. Today 42 (3) (1998) 183-189.

[3] K. Khammona, S. Assabumrungrat, W. Wiyaratn, Reviews on coupling of methane over catalysts for application in C₂ hydrocarbon production, J. Eng. Appl. Sci. 7 (7) (2012) 447-455.

[4] X. Fang, S. Li, J. Lin, Y. Chu, Oxidative coupling of methane onW-Mn catalysts, J. Mol. Catal. (China) 6 (6) (1992) 427-433.

[5] Z. Jiang, X. Fang, C. Yu, S. Li, Mn-Na₂WO₄/SiO₂ catalyst for oxidative coupling of methane-I. surface dispersion state and oxide support interaction, J. Mol. Catal. (China) 6 (6) (1992) 477-480.

[6] S. Ji, T. Xiao, S. Li, C. Xu, R. Hou, K.S. Coleman,M.L.H. Green, The relationship between the structure and the performance of Na-W-Mn/SiO₂ catalysts for the oxidative coupling of methane, Appl. Catal. A 225 (1-2) (2002) 271-284.

[7] S. Ji, T. Xiao, S. Li, L. Chou, B. Zhang, C. Xu, R. Hou, A.P.E. York, M.L.H. Green, Surface WO₄ tetrahedron: the essence of the oxidative coupling of methane overM-W-Mn/ SiO₂ catalysts, J. Catal. 220 (1) (2003) 47-56.

[8] A. Malekzadeh, A. Khodadadi, A.K. Dalai, M. Abedini, Oxidative coupling of methane over lithium doped (Mn + W)/SiO₂ catalysts, J. Nat. Gas Chem. 16 (2) (2007) 121-129.

[9] J. Wu, H. Zhang, S. Qin, C. Hu, La-promoted Na₂WO₄/Mn/SiO₂ catalysts for the oxidative conversion of methane simultaneously to ethylene and carbonmonoxide, Appl. Catal. A 323 (2007) 126-134.

[10] D. Schweer, L.Meeczko,M. Baerns, OCMin a fixed-bed reactor: Limits and perspectives, Catal. Today 21 (2-3) (1994) 357-369.

[11] M. Taniewski, A. Lachowicz, K. Skutil, Effective utilisation of the catalyst bed deactivating in the course of oxidative coupling of methane, Chem. Eng. Sci. 52 (6) (1997) 935-939.

[12] S. Pak, J.H. Lunsford, Thermal effects during the oxidative coupling of methane over Mn/Na₂WO₄/SiO₂ and Mn/Na₂WO₄/MgO catalysts, Appl. Catal. A 168 (1) (1998) 131-137.

[13] A. Talebizadeh, Y. Mortazavi, A.A. Khodadadi, Comparative study of the two-zone fluidized-bed reactor and the fluidized-bed reactor for oxidative coupling of methane over Mn/Na₂WO₄/SiO₂ catalyst, Fuel Process. Technol. 90 (10) (2009) 1319-1325.

[14] D. Pan, S. Ji, W. Wang, C. Li, Oxidative coupling of methane in a dual-bed reactor comprising of particle/cordierite monolithic catalysts, J. Nat. Gas Chem. 19 (6) (2010) 600-604.

[15] W. Wang, S. Ji, D. Pan, C. Li, A novel particle/monolithic two-stage catalyst bed reactor and their catalytic performance for oxidative coupling ofmethane, Fuel Process. Technol. 92 (3) (2011) 541-546.

[16] J. Shengfu, W. Wenhua, Particle/cordierite monolithic catalysts dual-bed reactor with beds-interspace supplementary oxygen and performance for oxidative coupling of methane, Int. J. Chem. React. Eng. 10 (1) (2012) 11.

[17] J.H.B.J. Hoebink, P.M. Couwenberg, G.B.Marin, Fixed bed reactor design for gas phase chain reactions catalysed by solids: the oxidative coupling of methane, Chem. Eng. Sci. 49 (24, Part 2) (1994) 5453-5463.

[18] C.T. Tye, A.R.Mohamed, S. Bhatia,Modeling of catalytic reactor for oxidative coupling of methane using La₂O₃/CaO catalyst, Chem. Eng. J. (Lausanne) 87 (1) (2002) 49-59.

[19] Y. Nakisa, G.M.H. Reza, Oxidative coupling of methane in a fixed bed reactor over perovskite catalyst: a simulation study using experimental kinetic model, J. Nat. Gas Chem. 17 (1) (2008) 8-16.

[20] Y. Nakisa, G.M.H. Reza, Modeling the oxidative coupling ofmethane: heterogeneous chemistry coupled with 3D flow field simulation, J. Nat. Gas Chem. 18 (1) (2009) 39-44.

[21] N.Holst, S. Jašo,H.R.Godini, S. Glöser,H. Arellano-Garcia, G.Wozny, J. Steinbach, Twodimensional model for oxidative coupling of methane in a packed-bed membrane reactor, Chem. Eng. Technol. 35 (2) (2012) 294-301.

[22] Z. Stansch, L. Mleczko, M. Baerns, Comprehensive kinetics of oxidative coupling of methane over the La₂O₃/CaO catalyst, Ind. Eng. Chem. Res. 36 (7) (1997) 2568-2579.

[23] G.K. Batchelor, An Introduction to Fluid Dynamics, 2nd edition CambridgeUniversity Press, Cambridge, 2000 131.

[24] S. Ergun, Fluid flow through packed columns, Chem. Eng. Prog. 48 (2) (1952) 89-94.

[25] A. Kushwaha, M. Poirier, R.E. Hayes, H. Sapoundjiev, Heat extraction from a flow reversal reactor in lean methane combustion, Chem. Eng. Res. Des. 83 (2) (2005) 205-213.

[26] T. Poinsot, D. Veynante, Theoretical and Numerical Combustion, 2nd edition Edwards, Philadelphia, 2005 13.

[27] S. Pak, P. Qiu, J.H. Lunsford, Elementary reactions in the oxidative coupling of methane over Mn/Na₂WO₄/SiO₂ and Mn/Na₂WO₄/MgO catalysts, J. Catal. 179 (1) (1998) 222-230.

[28] Y.S. Su, J.Y. Ying,W.H. Green Jr., Upper bound on the yield for oxidative coupling of methane, J. Catal. 218 (2) (2003) 321-333.

[29] H.S. Fogler, Elements of Chemical Reaction Engineering, 4th edition Pearson Education Internat., Upper Saddle River, 2006 108.