Visual investigation of slagging characteristics in a pilot-scale facility: Influence of deposition surface

doi:10.1016/j.cjche.2019.01.018

摘要/Abstract

摘要： Slagging is a major problem in boilers, especially the low-rank coal applied in boilers. In this study, the influence of heat transfer surface on the slagging characteristics of a pilot-scale furnace was investigated. Ni coatings were applied in modifying the deposition surface to control slagging. The growth characteristics of the slag were studied using an online digital image technique. Scanning electron microscopy linked with energy-dispersive X-ray analysis and X-ray diffraction (XRD) were applied to investigate the microstructure, semi-quantitative chemical composition, and mineralogy of slag samples. Ni coating demonstrated a positive effect on the mitigation of slagging. Results revealed that the thicknesses of the slag initially increased with experimental time and then inclined toward stable values for both cases (Case 1:substrate material; Case 2:modified surface). The stable thicknesses for Cases 1 and 2 were 4.91 mm and 3.95 mm, respectively. The heat transfer efficiency was improved by approximately 18.2% with the application of Ni coating for probe surface modification. The mechanism of the mitigation of slagging was investigated in this study. XRD results revealed that the content of alkali reduced when the surface was coated with Ni. The alkali significantly affected the adhesion behavior of the deposition. Hence, Ni coating showed potential in reducing slagging and increasing the efficiency of boilers. The overall study makes a contribution to a deep understanding of the effect of Ni coating on the growth characteristics of the slag.

关键词: Slagging, Deposition surface, Heat flux, Digital image technique

Abstract: Slagging is a major problem in boilers, especially the low-rank coal applied in boilers. In this study, the influence of heat transfer surface on the slagging characteristics of a pilot-scale furnace was investigated. Ni coatings were applied in modifying the deposition surface to control slagging. The growth characteristics of the slag were studied using an online digital image technique. Scanning electron microscopy linked with energy-dispersive X-ray analysis and X-ray diffraction (XRD) were applied to investigate the microstructure, semi-quantitative chemical composition, and mineralogy of slag samples. Ni coating demonstrated a positive effect on the mitigation of slagging. Results revealed that the thicknesses of the slag initially increased with experimental time and then inclined toward stable values for both cases (Case 1:substrate material; Case 2:modified surface). The stable thicknesses for Cases 1 and 2 were 4.91 mm and 3.95 mm, respectively. The heat transfer efficiency was improved by approximately 18.2% with the application of Ni coating for probe surface modification. The mechanism of the mitigation of slagging was investigated in this study. XRD results revealed that the content of alkali reduced when the surface was coated with Ni. The alkali significantly affected the adhesion behavior of the deposition. Hence, Ni coating showed potential in reducing slagging and increasing the efficiency of boilers. The overall study makes a contribution to a deep understanding of the effect of Ni coating on the growth characteristics of the slag.

Key words: Slagging, Deposition surface, Heat flux, Digital image technique

Hao Zhou, Jiakai Zhang, Weichen Ma, Kun Zhang, Chenying Zhou. Visual investigation of slagging characteristics in a pilot-scale facility: Influence of deposition surface[J]. 中国化学工程学报, 2019, 27(7): 1728-1734.

参考文献

[1] Y. Chang, W. Dai, K. Tsai, S. Chen, J. Chen, J.C.M. Kao, Reduction of PCDDs/PCDFs in MSWI fly ash using microwave peroxide oxidation in H₂SO₄/HNO₃ solution, Chemosphere 91(6) (2013) 864-868.
[2] Z. Tang, Q. Huang, Y. Yang, PCDD/Fs in fly ash from waste incineration in China:A need for effective risk management, Environ. Sci. Technol. 47(11) (2013) 5520-5521.
[3] Y. Pan, L. Yang, J. Zhou, J. Liu, G. Qian, N. Ohtsuka, M. Motegi, K. Oh, S. Hosono, Characteristics of dioxins content in fly ash from municipal solid waste incinerators in China, Chemosphere 92(7) (2013) 765-771.
[4] X. Ren, G. Zeng, L. Tang, J. Wang, J. Wan, Y. Liu, J. Yu, H. Yi, S. Ye, R. Deng, Sorption, transport and biodegradation-An insight into bioavailability of persistent organic pollutants in soil, Sci. Total Environ. 610-611(2018) 1154-1163.
[5] X. Ren, G. Zeng, L. Tang, J. Wang, J. Wan, H. Feng, B. Song, C. Huang, X. Tang, Effect of exogenous carbonaceous materials on the bioavailability of organic pollutants and their ecological risks, Soil Biol. Biochem. 116(2018) 70-81.
[6] O. Ghimpet eanu, M. Militaru, M.L. Scippo, Dioxins and polychlorinated biphenyls contamination in poultry liver related to food safety-A review, Food Control 38(2014) 47-53.
[7] K. Okawa, K. Suzuki, T. Takeshita, K. Nakano, Degradation of chemical substances using wet peroxide oxidation under mild conditions, J. Hazard. Mater. 127(1-3) (2005) 68-72.
[8] Y. Misaka, K. Yamanaka, K. Takeuchi, K. Sawabe, K. Shobatake, Removal of PCDDs/DFs and dl-PCBs in MWI fly ash by heating under vacuum, Chemosphere 64(4) (2006) 619-627.
[9] E. Weidemann, L. Lundin, J. Boily, Thermal decomposition of municipal solid waste fly ash and desorption of polychlorinated dibenzo-p-dioxins and furans from fly ash surfaces, Environ. Sci. Pollut. Res. 23(22) (2016) 22843-22851.
[10] L. Lundin, S. Marklund, Thermal degradation of PCDD/F in municipal solid waste ashes in sealed glass ampules, Environ. Sci. Technol. 39(10) (2005) 3872-3877.
[11] Z. Chen, Q. Mao, S. Lu, A. Buekens, S. Xu, X. Wang, J. Yan, Dioxins degradation and reformation during mechanochemical treatment, Chemosphere 180(2017) 130-140.
[12] J. Xie, Y. Hu, D. Chen, B. Zhou, Hydrothermal treatment of MSWI fly ash for simultaneous dioxins decomposition and heavy metal stabilization, Front. Environ. Sci. Eng. China 4(1) (2010) 108-115.
[13] Y. Hu, P. Zhang, D. Chen, B. Zhou, J. Li, X. Li, Hydrothermal treatment of municipal solid waste incineration fly ash for dioxin decomposition, J. Hazard. Mater. 207-208(2012) 79-85.
[14] V. H, S. L, Thermal-behavior of PCDD/PCDF in fly-ash from municipal incinerators, Chemosphere 15(1986) 1373-1378.
[15] P.S. Kulkarni, J.G. Crespo, C.A.M. Afonso, Dioxins sources and current remediation technologies-A review, Environ. Int. 34(1) (2008) 139-153.
[16] H. Yamaguchi, E. Shibuya, Y. Kanamaru, K. Uyama, M. Nishioka, N. Yamasaki, Hydrothermal decomposition of PCDDs/PCDFs in MSWI fly ash, Chemosphere 32(1) (1996) 203-208.
[17] Y. Jin, X. Ma, X. Jiang, H. Liu, X. Li, J. Yan, Hydrothermal degradation of polychlorinated dibenzo-p-dioxins and polychlorinated dibenzofurans in fly ash from municipal solid waste incineration under non-oxidative and oxidative conditions, Energy Fuel 27(1) (2012) 414-420.
[18] J. Behin, S.S. Bukhari, V. Dehnavi, H. Kazemian, S. Rohani, Using coal fly ash and wastewater for microwave synthesis of LTA zeolite, Chem. Eng. Technol. 37(9) (2014) 1532-1540.
[19] Q. Qiu, X. Jiang, S. Lu, M. Ni, Effects of microwave-assisted hydrothermal treatment on the major heavy metals of municipal solid waste incineration fly ash in a circulating fluidized bed, Energy Fuel 30(7) (2016) 5945-5952.
[20] Q. Qiu, X. Jiang, G. Lv, S. Lu, M. Ni, Stabilization of heavy metals in municipal solid waste incineration fly ash in circulating fluidized bed by microwaveassisted hydrothermal treatment with additives, Energy Fuel 30(9) (2016) 7588-7595.
[21] Q. Qiu, X. Jiang, Z. Chen, S. Lu, M. Ni, Microwave-assisted hydrothermal treatment with soluble phosphate added for heavy metals solidification in MSWI fly ash, Energy Fuel 31(5) (2017) 5222-5232.
[22] Y. Chang, W. Fan, W. Dai, H. Hsi, C. Wu, C. Chen, Characteristics of PCDD/F content in fly ash discharged from municipal solid waste incinerators, J. Hazard. Mater. 192(2) (2011) 521-529.
[23] G. Song, S.H. Kim, Y. Seo, S. Kim, Dechlorination and destruction of PCDDs/PCDFs in fly ashes from municipal solid waste incinerators by low temperature thermal treatment, Chemosphere 71(2) (2008) 248-257.
[24] R. Weber, T. Takasuga, K. Nagai, H. Shiraishi, T. Sakurai, T. Matuda, M. Hiraoka, Dechlorination and destruction of PCDD, PCDF and PCB on selected fly ash from municipal waste incineration, Chemosphere 46(9-10) (2002) 1255-1262.
[25] L. Lundin, J. Aurell, S. Marklund, The behavior of PCDD and PCDF during thermal treatment of waste incineration ash, Chemosphere 84(3) (2011) 305-310.
[26] M. Al-Harahsheh, S.W. Kingman, Microwave-assisted leaching-A review, Hydrometallurgy 73(3-4) (2004) 189-203.
[27] I. Hslonen, K. Tuppurainen, J. Ruuskanen, Formation of aromatic chlorinated compounds catalyzed by copper and iron, Chemosphere 34(12) (1997) 2649-2662.
[28] D.Z. Chen, Y.Y. Hu, P.F. Zhang, Hydrothermal treatment of incineration fly ash for PCDD/Fs decomposition:the effect of iron addition, Environ. Technol. 33(22-24) (2012) 2517-2523.
[29] H. Fiedler, C. Lau, G. Eduljee, Statistical analysis of patterns of PCDDs and PCDFs in stack emission samples and identification of a marker congener, Waste Manag. Res. (18) (2000) 283-292.