SCI和EI收录∣中国化工学会会刊

Chinese Journal of Chemical Engineering ›› 2015, Vol. 23 ›› Issue (7): 1065-1076.DOI: 10.1016/j.cjche.2014.10.022

• 综述 •    下一篇

Mixing time in stirred vessels: A review of experimental techniques

Gabriel Ascanio   

  1. Center of Applied Sciences and Technological Development, National Autonomous University of Mexico, Circuito Exterior, Ciudad Universitaria, DF 04510 Mexico
  • 收稿日期:2013-12-13 修回日期:2014-10-28 出版日期:2015-07-28 发布日期:2015-08-21
  • 通讯作者: Gabriel Ascanio

Mixing time in stirred vessels: A review of experimental techniques

Gabriel Ascanio   

  1. Center of Applied Sciences and Technological Development, National Autonomous University of Mexico, Circuito Exterior, Ciudad Universitaria, DF 04510 Mexico
  • Received:2013-12-13 Revised:2014-10-28 Online:2015-07-28 Published:2015-08-21
  • Contact: Gabriel Ascanio
  • Supported by:

    Supported by DGAPA-UNAM through the grant IN-108312.

摘要: Mixing time is defined as the time required for achieving a certain degree of homogeneity of injected tracer in a unit operation vessel. It has been used as a key parameter for assessing the performance of amixing system. From an experimental standpoint, several techniques have been developed for measuring the mixing time. Based on the disturbances to flow, they can be classified into two groups: non-intrusive and intrusive. However, depending on the type of data generated, they can be also classified into direct measurements and indirect measurements (Eulerian and Lagrangian). Since the techniques available for measuring mixing times in an agitated tank do not provide the same information, its choice depends on several factors, namely: accuracy, reproducibility, suitability, cost, sampling speed, type of data, and processing time. A review of the experimental techniques reported in the literature in the last 50 years for themeasurement of mixing time in stirred vessels under single and gas-liquid flowconditions with Newtonian and non-Newtonian fluids in the laminar and turbulent regimeis made, and a comparison between these techniques is also presented.

关键词: Mixing time, Stirred vessel, Homogeneity

Abstract: Mixing time is defined as the time required for achieving a certain degree of homogeneity of injected tracer in a unit operation vessel. It has been used as a key parameter for assessing the performance of amixing system. From an experimental standpoint, several techniques have been developed for measuring the mixing time. Based on the disturbances to flow, they can be classified into two groups: non-intrusive and intrusive. However, depending on the type of data generated, they can be also classified into direct measurements and indirect measurements (Eulerian and Lagrangian). Since the techniques available for measuring mixing times in an agitated tank do not provide the same information, its choice depends on several factors, namely: accuracy, reproducibility, suitability, cost, sampling speed, type of data, and processing time. A review of the experimental techniques reported in the literature in the last 50 years for themeasurement of mixing time in stirred vessels under single and gas-liquid flowconditions with Newtonian and non-Newtonian fluids in the laminar and turbulent regimeis made, and a comparison between these techniques is also presented.

Key words: Mixing time, Stirred vessel, Homogeneity