On the enhanced properties of composite asphalt via adding surface modified calcium sulfate whisker-SBR

doi:10.1016/j.cjche.2024.07.019

摘要/Abstract

摘要： With the aim of improving the durability and safety, erosion time, and cost-effective of asphalt road, a composite of modified calcium sulfate whisker-styrene butadiene rubber modified asphalt (MCSW-SBRMA) was prepared via thermal doping. Firstly, stearic acid and titanate coupling agent (NDZ-201) were used as a modifier to transform calcium sulfate whisker (CSW) into MCSW via wet modification method at 60 ℃ and anhydrous ethanol as a dispersant. What is more, the optimum loading of modifier (a mixture of 25% stearic acid + 75% NDZ-201) was found to be at 2% to prepare MCSW. Subsequently, a composite of MCSW-SBRMA was prepared with different loading of MCSW (i.e. 2% to 8%) to enhance the softening point of asphalt. In this study, it was found that 4% of modifiers was the best composition to improve the MCSW-SBRMA properties as elucidated in the orthogonal experiment table L₁₆(42). The effects of MCSW and SBR addition on several properties of asphalt were studied by multiple routine tests including penetration, segregation test, and so on. The results show that: 2% to 8% MCSW can increase the softening point of SBR modified asphalt (SBRMA) by 7% to 8%. 4% MCSW increased the PG of SBRMA from 64 to 70, which greatly improved the high temperature characteristics of asphalt. The 5 ℃ ductility of MCSW-SBRMA is greater than 100 cm, which greatly improves the low temperature performance of asphalt. Through the application of fluorescence microscopy (FM), Fourier transform infrared spectroscopy (FTIR), Scanning electron microscopy (SEM), and energy dispersive spectroscopy (SEM-EDS), it has been demonstrated that MCSW-SBR effectively alters asphalt in a highly uniform manner, with some MCSW still retaining large cross sections, thereby facilitating the dispersion of shear stress and enhancing the durability of asphalt.

关键词: Surface modification, Calcium sulfate whisker, SBR, Modified asphalt, High temperature performance

Abstract: With the aim of improving the durability and safety, erosion time, and cost-effective of asphalt road, a composite of modified calcium sulfate whisker-styrene butadiene rubber modified asphalt (MCSW-SBRMA) was prepared via thermal doping. Firstly, stearic acid and titanate coupling agent (NDZ-201) were used as a modifier to transform calcium sulfate whisker (CSW) into MCSW via wet modification method at 60 ℃ and anhydrous ethanol as a dispersant. What is more, the optimum loading of modifier (a mixture of 25% stearic acid + 75% NDZ-201) was found to be at 2% to prepare MCSW. Subsequently, a composite of MCSW-SBRMA was prepared with different loading of MCSW (i.e. 2% to 8%) to enhance the softening point of asphalt. In this study, it was found that 4% of modifiers was the best composition to improve the MCSW-SBRMA properties as elucidated in the orthogonal experiment table L₁₆(42). The effects of MCSW and SBR addition on several properties of asphalt were studied by multiple routine tests including penetration, segregation test, and so on. The results show that: 2% to 8% MCSW can increase the softening point of SBR modified asphalt (SBRMA) by 7% to 8%. 4% MCSW increased the PG of SBRMA from 64 to 70, which greatly improved the high temperature characteristics of asphalt. The 5 ℃ ductility of MCSW-SBRMA is greater than 100 cm, which greatly improves the low temperature performance of asphalt. Through the application of fluorescence microscopy (FM), Fourier transform infrared spectroscopy (FTIR), Scanning electron microscopy (SEM), and energy dispersive spectroscopy (SEM-EDS), it has been demonstrated that MCSW-SBR effectively alters asphalt in a highly uniform manner, with some MCSW still retaining large cross sections, thereby facilitating the dispersion of shear stress and enhancing the durability of asphalt.

Key words: Surface modification, Calcium sulfate whisker, SBR, Modified asphalt, High temperature performance

Aoqi Cui, Emmerson Hondo, Nur Fatihah Tajul Arifin, Yanpeng Pei, Xuan Su, Zhonghe Chen. On the enhanced properties of composite asphalt via adding surface modified calcium sulfate whisker-SBR[J]. 中国化学工程学报, 2024, 76(12): 187-200.

参考文献

[1] Y.J. Meng, C.Y. Zhang, Z.R. Liu, L.S. Ling, J.C. Lei, G.P. Fang, X.W. Luo, Recycling of waste printed circuit boards: effect of PCB on aging resistance property of SBR modified asphalt, J. Build. Eng. 72 (2023) 106617.
[2] Y.W. Kang, Analysis and countermeasures of early damage causes of highway asphalt pavement, Transpo World (34) (2017) 78-79. (in Chinese).
[3] L.Q. Zhang, Study on low temperature cracking resistance of SBR modified asphalt, Transpo World (29) (2022) 48-50. (in Chinese).
[4] F. Yu, reportExperimental Investigation on Asphalt Mixture Low Temperature Performance Index, Master Thesis, Hubei University of Technology, China, 2015. (in Chinese).
[5] C.W. Gong, Research on Low Temperature Cracking Evaluation and Control Index of Asphalt Pavement Based on LTPP, Master Tghesis, Harbin Institute of Technology, China, 2013. (in Chinese).
[6] Y.T. Liu, Z.L. Yang, H. Luo, L. Xi, Preparation, characterization, and properties of asphalt modified by surface-treated anhydrous calcium sulfate whiskers, Construct. Build. Mater. 384 (2023) 131370.
[7] S.S. Ren, M. Liang, W.Y. Fan, Y.Z. Zhang, C.D. Qian, Y. He, J.T. Shi, Investigating the effects of SBR on the properties of Gilsonite modified asphalt, Construct. Build. Mater. 190 (2018) 1103-1116.
[8] J.D. Li, Systematic study on the application of calcium sulfate whisker in asphalt pavement, J. East China Jiaot. Univ. 30 (6) (2013) 72-77. (in Chinese).
[9] J.H. Ma, C.Q. Feng, The application study of calcium sulfate whisker in road modified asphalt (Ⅰ), Petrol. Asph. 19 (6) (2005) 21-25. (in Chinese).
[10] J.H. Ma, Preparation of Calcium Sulphate Whisker and its Application Study in the Paving Asphalt, Master Thesis, Shandong University of Science and Technology, China, 2005. (in Chinese).
[11] X.S. Wang, Road performance of high modulus asphalt concrete additive calcium sulfate whisker, J. Chongqing Jiaotong Univ. Nat. Sci. 30 (6) (2011) 1331-1334. (in Chinese).
[12] J.D. Li, Research of thermodynamic behavior of calcium sulfate whisker in asphal, Mater. Rev. 28 (24) (2014) 402-406. (in Chinese).
[13] G.Y. Li, J.F. Li, Y. Gao, Y.Q. Liu, Research on temperature sensitivity and viscosity of calcium sulphate whisker modified asphalt, N. Chem. Mater. 45 (9) (2017) 235-237.
[14] S.J.Shen, X.S. Wang, H.Y. Zhou, B.W. Dong, Z.R. Huang, Effect of surface modified calcium sulfate whisker on asphalt pavement performance, Water Resources Planning and Design (06) 2021 101-106. (in Chinese).
[15] E. H. Fini, A. M. Hung, A. Roy, Active mineral fillers arrest migrations of alkane acids to the interface of bitumen and siliceous surfaces, ACS Sustainable Chem. Eng. 7 (12) (2019) 10340-10348.
[16] M.J. Zhang, G. Chen, X.H. Jiao, Study on road performance of SBR modified asphalt in cold regions, J. Shenyang Jianzhu Univ. Nat. Sci. 25 (5) (2009) 858-862. (in Chinese).
[17] J.P. Zhou, Q.H. Zhong, D.C. Liu, The influence of dosage and stabilizer to the performance of SBR/SBS modified asphalt, Petroleum asphalt (01) (2008):24-28. (in Chinese).
[18] J.P. Zhou, C.M. Xu, Y. Mao, D.C. Liu, Research on modified asphalt with powered SBR, Petroleum asphalt (04) (2008) 62-65. (in Chinese).
[19] T. Zhou, F. Yu, L. Li, Z. Dong, E. H. Fini, Swelling-degradation dynamic evolution behaviors of bio-modified rubberized asphalt under thermal conditions, J. Clean. Prod. 426 (2023) 139061.
[20] S.J. Shen, Study on Properties of Calcium Sulfate Whisker-Styrene Butadiene Rubber Compound Modified Asphalt and Mixture, Master Thesis, Zhejiang Sci-Tech University, China, 2021. (in Chinese).
[21] ASTM D5/D5M-20, Standard Test Method for Penetration of Bituminous Materials, ASTM International, USA, 2008.
[22] ASTM D36/D36M, Standard Test Method for Softening Point of Bitumen (Ring-and Ball Apparatus), ASTM International, USA, 2014.
[23] ASTM D113, Standard Test Method for Ductility of Asphalt Materials, ASTM International, USA, 2017.
[24] ASTM D2872, Standard Test Method for Effect of Heat and Air on a Moving Film of Asphalt (Thin-film Oven Test), ASTM International, USA, 2004.
[25] GB/T 19281-2003, Analytical Method for Calcium Carbonate, Standards Press of China, China, 2014. (in Chinese).
[26] W.S. Luo, Y.Y. Wang, G. Yang, Compound titanate and its effect on the properties of ultrafine calcium carbonate/PP composites, Journal of Nanchang Hangkong University Natural Sciences 34 (3) (2020) 53-60. (in Chinese).
[27] Y. Wang,; Y.W. Zeng, K.Y. Qin, Study on modification of ground calcium carbonate by stearic acid and titanate coupling agent, Inorganic chemicals industry 48 (6) (2016) 38-40. (in Chinese).
[28] Q.L. Zhang, Study on high temperature performance of nano-ZnO/SBR composite modified asphalt, The World of Building Materials 43 (5) (2022) 18 -20+29. (in Chinese).
[29] P. Sun, S. Han, H.L. Zhang, Z.Y. Wang, O.M. Xu, High-temperature performance of nano-CaCO₃/SBR modified asphalt and mixture, Mater. Rev. 30 (8) (2016) 122-126.
[30] Y.H. Xue, C.C. Liu, S.T. Lv, D.D. Ge, Z.H. Ju, G.P. Fan, Research on rheological properties of CNT-SBR modified asphalt, Construct. Build. Mater. 361 (2022) 129587.
[31] P. Cong; Y. Tian, N. Liu, P. Xu, Investigation of epoxy-resin-modified asphalt binder, J. Appl. Poly-mer. Sci. 133 (21) (2016) 43401.
[32] ASTM D7175, Standard Test Method for Determining the Rheological Properties of Asphalt Binder Using a Dynamic Shear Rheometer, ASTM International, USA, 2008.
[33] S. Nizamuddin, M. Jamal, R. Gravina, F. Giustozzi, Recycled plastic as bitumen modifier: the role of recycled linear low-density polyethylene in the modification of physical, chemical and rheological properties of bitumen, J. Clean. Prod. 266 (2020) 121988.
[34] K.F. Liu, K. Zhang, X.M. Shi, Performance evaluation and modification mechanism analysis of asphalt binders modified by graphene oxide, Construct. Build. Mater. 163 (2018) 880-889.
[35] M.X. Gao, Y.H. Xue, P. Guan, F.L. Yuan, Influence mechanism of epoxy resin and curing agent on high-temperature performance of asphalt, Sains Malays. 49 (3) (2020) 661-669.
[36] Y.X. Cui, P.W. Hao, High temperature performance of rubber modified asphalt based on MSCR test, Road Machinery & Construction Mechanization 36 (2019) 47-51. (in Chinese).
[37] A. Ghavibazoo, M. Abdelrahman, M. Ragab, Mechanism of crumb rubber modifier dissolution into asphalt matrix and its effect on final physical properties of crumb rubber-modified binder, Transp. Res. Rec. J. Transp. Res. Board 2370 (1) (2013) 92-101.