SCI和EI收录∣中国化工学会会刊

›› 2010, Vol. 18 ›› Issue (2): 202-206.

• • 上一篇    下一篇

Clathrate Hydrate Capture of CO2 from Simulated Flue Gas with Cyclopentane/Water Emulsion

李士凤1,2, 樊栓狮2, 王金渠1, 郎雪梅2, 王燕鸿2   

  1. 1. State Key Laboratory of Fine Chemicals, School of Chemical Engineering, Dalian University of Technology, Dalian 116012, China;
    2. Key Laboratory of Enhanced Heat Transfer and Energy Conversation, Ministry of Education, South China University of Technology, Guangzhou 510640, China
  • 收稿日期:2009-09-01 修回日期:2009-12-26 出版日期:2010-04-28 发布日期:2010-04-28
  • 通讯作者: FAN Shuanshi,E-mail:ssfan@scut.edu.cn
  • 基金资助:
    Supported by the National High Technology Research and Development Program of China(2007AA03Z229);the National Natural Science Foundation of China(20876019)

Clathrate Hydrate Capture of CO2 from Simulated Flue Gas with Cyclopentane/Water Emulsion

LI Shifeng1,2, FAN Shuanshi2, WANG Jinqu1, LANG Xuemei2, WANG Yanhong2   

  1. 1. State Key Laboratory of Fine Chemicals, School of Chemical Engineering, Dalian University of Technology, Dalian 116012, China;
    2. Key Laboratory of Enhanced Heat Transfer and Energy Conversation, Ministry of Education, South China University of Technology, Guangzhou 510640, China
  • Received:2009-09-01 Revised:2009-12-26 Online:2010-04-28 Published:2010-04-28
  • Supported by:
    Supported by the National High Technology Research and Development Program of China(2007AA03Z229);the National Natural Science Foundation of China(20876019)

摘要: Capture of CO2 by hydrate is one of the attractive technologies for reducing greenhouse effect.The primary challenges are the large energy consumption,low hydrate formation rate and separation efficiency.This work presents a new method for capture of CO2 from simulated flue gasCO2(16.60%,by mole)/N2 binary mixture by formation of cyclopentane(CP) hydrates at initial temperature of 8.1℃ with the feed pressures from 2.49 to 3.95 MPa.The effect of cyclopentane and cyclopentane/water emulsion on the hydrate formation rate and CO2 separation efficiency was studied in a 1000 ml stirred reactor.The results showed the hydrate formation rate could be increased remarkably with cyclopentane/water emulsion.CO2 could be enriched to 43.97%(by mole) and 35.29%(by mole) from simulated flue gas with cyclopentane and cyclopentane/water(O/W) emulsion,respectively,by one stage hydrate separation under low feed pressure.CO2 separation factor with cyclopentane was 6.18,higher than that with cyclopentane/water emulsion(4.01), in the range of the feed pressure.The results demonstrated that cyclopentane/water emulsion is a good additive for efficient hydrate capture of CO2.

关键词: cyclopentane, hydrate, CO2 capture, emulsion, flue gas

Abstract: Capture of CO2 by hydrate is one of the attractive technologies for reducing greenhouse effect.The primary challenges are the large energy consumption,low hydrate formation rate and separation efficiency.This work presents a new method for capture of CO2 from simulated flue gasCO2(16.60%,by mole)/N2 binary mixture by formation of cyclopentane(CP) hydrates at initial temperature of 8.1℃ with the feed pressures from 2.49 to 3.95 MPa.The effect of cyclopentane and cyclopentane/water emulsion on the hydrate formation rate and CO2 separation efficiency was studied in a 1000 ml stirred reactor.The results showed the hydrate formation rate could be increased remarkably with cyclopentane/water emulsion.CO2 could be enriched to 43.97%(by mole) and 35.29%(by mole) from simulated flue gas with cyclopentane and cyclopentane/water(O/W) emulsion,respectively,by one stage hydrate separation under low feed pressure.CO2 separation factor with cyclopentane was 6.18,higher than that with cyclopentane/water emulsion(4.01), in the range of the feed pressure.The results demonstrated that cyclopentane/water emulsion is a good additive for efficient hydrate capture of CO2.

Key words: cyclopentane, hydrate, CO2 capture, emulsion, flue gas