Heat Transfer in a Liquid-Solid Circulating Fluidized Bed Reactor with Low Surface Tension Media

doi:10.1016/S1004-9541(13)60556-X

Chinese Journal of Chemical Engineering ›› 2013, Vol. 21 ›› Issue (8): 844-849.DOI: 10.1016/S1004-9541(13)60556-X

• 催化、动力学与反应工程 • 上一篇下一篇

Heat Transfer in a Liquid-Solid Circulating Fluidized Bed Reactor with Low Surface Tension Media

H. R. Jin¹, H. Lim¹, D. H. Lim¹, Y. Kang¹, Ki-Won Jun²

1 Chemical Engineering, Chungnam National University, Daejeon, Korea;
2 Korea Chemical Technology Division, Korea Research Institute of Chemical Technology, Daejeon, Korea

收稿日期:2011-11-15 修回日期:2012-07-12 出版日期:2013-08-28 发布日期:2013-08-24
通讯作者: Y. Kang
基金资助:
Supported by Korea Institute of Energy Technology Evaluation and Planning (KETEP) and GTL Technology Development Consortium (Korean National Oil Corp., Korea Gas Corp., Daelim Industrial Co. and Hyundai Engineering Co.) under "Energy Efficiency & Resources Programs" of the Ministry of Knowledge Economy, Republic of Korea.

Heat Transfer in a Liquid-Solid Circulating Fluidized Bed Reactor with Low Surface Tension Media

H. R. Jin¹, H. Lim¹, D. H. Lim¹, Y. Kang¹, Ki-Won Jun²

1 Chemical Engineering, Chungnam National University, Daejeon, Korea;
2 Korea Chemical Technology Division, Korea Research Institute of Chemical Technology, Daejeon, Korea

Received:2011-11-15 Revised:2012-07-12 Online:2013-08-28 Published:2013-08-24
Supported by:
Supported by Korea Institute of Energy Technology Evaluation and Planning (KETEP) and GTL Technology Development Consortium (Korean National Oil Corp., Korea Gas Corp., Daelim Industrial Co. and Hyundai Engineering Co.) under "Energy Efficiency & Resources Programs" of the Ministry of Knowledge Economy, Republic of Korea.

摘要/Abstract

摘要： Heat transfer characteristics between the immersed heater and the bed content were studied in the riser of a liquid-solid circulating fluidized bed, whose diameter and height were 0.102 m (ID) and 2.5 m, respectively. Effects of liquid velocity, particle size, surface tension of liquid phase and solid circulation rate on the overall heat transfer coefficient were examined. The heat transfer coefficient increased with increasing particle size or solid circulation rate due to the higher potential of particles to contact with the heater surface and promote turbulence near the heater surface. The value of heat transfer coefficient increased gradually with increase in the surface tension of liquid phase, due to the slight increase of solid holdup. The heat transfer coefficient increased with the liquid velocity even in the higher range, due to the solid circulation prevented the decrease in solid holdup, in contrast to that in the conventional liquid-solid fluidized beds. The values of heat transfer coefficient were well correlated in terms of dimensionless groups as well as operating variables.

关键词: heat transfer coefficient, liquid-solid, circulating fluidized bed, liquid surface tension, solid circulation rate, particle size

Abstract: Heat transfer characteristics between the immersed heater and the bed content were studied in the riser of a liquid-solid circulating fluidized bed, whose diameter and height were 0.102 m (ID) and 2.5 m, respectively. Effects of liquid velocity, particle size, surface tension of liquid phase and solid circulation rate on the overall heat transfer coefficient were examined. The heat transfer coefficient increased with increasing particle size or solid circulation rate due to the higher potential of particles to contact with the heater surface and promote turbulence near the heater surface. The value of heat transfer coefficient increased gradually with increase in the surface tension of liquid phase, due to the slight increase of solid holdup. The heat transfer coefficient increased with the liquid velocity even in the higher range, due to the solid circulation prevented the decrease in solid holdup, in contrast to that in the conventional liquid-solid fluidized beds. The values of heat transfer coefficient were well correlated in terms of dimensionless groups as well as operating variables.

Key words: heat transfer coefficient, liquid-solid, circulating fluidized bed, liquid surface tension, solid circulation rate, particle size

H. R. Jin, H. Lim, D. H. Lim, Y. Kang, Ki-Won Jun. Heat Transfer in a Liquid-Solid Circulating Fluidized Bed Reactor with Low Surface Tension Media[J]. Chinese Journal of Chemical Engineering, 2013, 21(8): 844-849.

H. R. Jin, H. Lim, D. H. Lim, Y. Kang, Ki-Won Jun. Heat Transfer in a Liquid-Solid Circulating Fluidized Bed Reactor with Low Surface Tension Media[J]. Chin.J.Chem.Eng., 2013, 21(8): 844-849.

参考文献

1 Atta, A., Razzak, S.A., Nigam, K.D.P., Zhu, J.X., "Gas-liquid-solid circulating fluidized bed reactors: Characteristics and applications", Ind. Eng. Chem. Res., 48, 7876-7892 (2009).

2 Liang, W.G., Yu, Z.Q., Jin, Y., Wang, Z., Yang, Y., He, M.Y., Min, E.Z., "Synthesis of linear alkyl benzene in a liquid-solid circulating fluidized bed reactor", J. Chem. Tech. Biotechnol., 62, 98-102 (1995).

3 Lan, Q., Bassi, A., Zhu, J.X., Margaritis, A., "Continuous protein recovery from whey using liquid-solid circulating fluidized bed ion-exchange extraction", Biotechnol. Bioeng., 78, 157-163 (2002).

4 Zhu, J., Zheng, Y., Karmanev, D., Bassi, A., "Gas-liquid-solid circulating fluidized beds and their potential applications to bioreactor engineering", Can. J. Chem. Eng., 78, 82-94 (2000).

5 Fan, L.S., Gas-Liquid-Solid Fluidization Engineering, Butterworths, Boston, U. S. A (1989)

6 Kim, S.D., Kang, Y., "Heat and mass transfer in three-phase fluidized-bed reactors—An overview", Chem. Eng. Sci., 52, 3639-3660 (1997).

7 Kim, S.D., Kang, Y., "Hydrodynamics, heat and mass transfer in inverse and circulating three-phase fluidized-bed reactors for wastewater treatment", Stud. Surf. Sci. Catal., 159, 103-108 (2006).

8 Kuramoto, K., Tsutsumi, A., Chiba, T., "High-velocity fluidization of solid particles in a liquid-solid circulating fluidized bed system", Can. J. Chem. Eng., 77, 291-298 (1999).

9 Shin, K.S., Song, P.S., Lee, C.G., Kang, S.H., Kang, Y., Kim, S.D., "Heat transfer coefficient in viscous liquid-solid circulating fluidized beds", AIChE J., 51, 671-677 (2005).

10 Hashizume, K., Kimura, Y., "Heat transfer characteristics of liquid-solid circulating fluidized beds", Heat Transfer-Asian Res., 37, 127-137 (2008).

11 Kim, S.H., Cho, Y.J., Song, P.S., Kang, Y., Kim, S.D., "Phase holdup characteristics in three-phase circulating fluidized beds", Korean Chem. Eng. Res., 37, 916-920 (1999). (in Korean)

12 Kang, T.G., Song, P.S., Choi, G.S., Cho, Y.J., Kim, S.D., "Heat transfer coefficient in a three-phase circulating fluidized-bed bioreactor", Korean Chem. Eng. Res., 40, 640-645 (2002). (in Korean)

13 Assael, M.J., Charitidou, E., Wakeham, W.A., "Absolute measurements of the thermal conductivity of the mixtures of alcohols with water", Int. J. Therm. Phys., 10, 793-803 (1989).

14 Fan, L.T., Kang, Y., Yashima, M., Neogi, D., "Stochastic behavior of fluidized particles in a liquid-solid fluidized bed", Chem. Eng. Commun., 135, 146-160 (1995).

15 Woo, K.J., Kim, J.S., Kang, Y., Kim, S.D., "Effects of chaotic temperature fluctuations on the heat transfer coefficient in liquid-liquid-solid fluidized beds", Chem. Eng. Technol., 24, 829-834 (2001).

16 Kim, J.S., Woo, K.J., Kang, Y., Nam, C.H., Kim, S.D., "Temperature fluctuations and heat transfer in liquid drop columns", J. Chem. Eng. Japan, 34, 185-192 (2001).

17 Lim, D.H., Jang, J.H., Jin, H.R., Kang, Y., Jung, H., Kim, S.D., "Heat transfer in three-phase(G/L/S) circulating fluidized beds with low surface tension media", Chem. Eng. Sci., 66, 3145-3151 (2011).

18 Atkins, P., Paula, J., Physical Chemistry, 7th edition, Oxford University Press, UK, 150-154 (2002).

[1]	Feng Jiang, Xiao Li, Guopeng Qi, Xiulun Li. Effects of particle type on the particle fluidization and distribution in a liquid–solid circulating fluidized bed boiler[J]. 中国化学工程学报, 2023, 54(2): 53-66.
[2]	Zhibin Ma, Xueli Zhang, Guangjun Lu, Yanxia Guo, Huiping Song, Fangqin Cheng. Hydrothermal synthesis of zeolitic material from circulating fluidized bed combustion fly ash for the highly efficient removal of lead from aqueous solution[J]. 中国化学工程学报, 2022, 47(7): 193-205.
[3]	Feng Jiang, Di Xu, Ruijia Li, Guopeng Qi, Xiulun Li. Particle collision behavior and heat transfer performance in a Na₂SO₄ circulating fluidized bed evaporator[J]. 中国化学工程学报, 2022, 46(6): 40-52.
[4]	Shidong Xue, Jingkun Han, Xi Xi, Junyi Zhao, Zhong Lan, Rongfu Wen, Xuehu Ma. Rapid velocity reduction and drift potential assessment of off-nozzle pesticide droplets[J]. 中国化学工程学报, 2022, 46(6): 243-254.
[5]	Xianchao Liang, Limin He, Xiaoming Luo, Qingping Li, Yuanpeng You, Yiqiu Xu. Experimental study on sand particles accumulation, migration and separation efficiency in slug catcher[J]. 中国化学工程学报, 2021, 32(4): 134-143.
[6]	Yangjun Wei, Leming Cheng, Liyao Li. An analysis approach of mass and energy balance in a dual-reactor circulating fluidized bed system[J]. 中国化学工程学报, 2021, 40(12): 18-26.
[7]	Shuaifeng Zhang, Qinghua Zhang, Jianzhuang Shang, Zaisha Mao, Chao Yang. Measurement methods of particle size distribution in emulsion polymerization[J]. 中国化学工程学报, 2021, 39(11): 1-15.
[8]	Ziqing Yuan, Ziyu Chen, Jianxin Mao, Renxian Zhou. The size effect and high activity of nanosized platinum supported catalysts for low temperature oxidation of volatile organic compounds[J]. 中国化学工程学报, 2021, 39(11): 135-143.
[9]	Huan Zhang, Shicheng Zhao, Zhong Xin, Chunlin Ye, Zhi Li, Jincheng Xia, Jiaorong Li. Mechanism of size effects of a filler on the wear behavior of ultrahigh molecular weight polyethylene[J]. 中国化学工程学报, 2020, 28(7): 1950-1963.
[10]	Hanbin Wang, Zhengming Gao, Bingjie Wang, Yuyun Bao, Ziqi Cai. Gas dispersion and solid suspension in a three-phase stirred tank with triple impellers[J]. 中国化学工程学报, 2020, 28(5): 1195-1202.
[11]	Xiuli Zhang, Chunhu Li, Qingjie Guo, Kelei Huang. Performance of anaerobic fluidized bed microbial fuel cell with different porous anodes[J]. 中国化学工程学报, 2020, 28(3): 846-853.
[12]	Yefeng Zhou, Yifan Han, Yujian Lu, Hongcun Bai, Xiayi Hu, Xincheng Zhang, Fanghua Xie, Xiao Luo, Jingdai Wang, Yongrong Yang. Numerical simulations and comparative analysis of two- and three-dimensional circulating fluidized bed reactors for CO₂ capture[J]. 中国化学工程学报, 2020, 28(12): 2955-2967.
[13]	Yazhao Liu, Zhi hao Li, Guangwen Chu, Lei Shao, Yong Luo, Jianfeng Chen. Liquid-solid mass transfer in a rotating packed bed reactor with structured foam packing[J]. 中国化学工程学报, 2020, 28(10): 2507-2512.
[14]	Hai-Sam Do, Tuyet-Suong Tran, Zhennan Han, Xi Zeng, Shiqiu Gao, Guangwen Xu. Synergetic NO reduction by biomass pyrolysis products simulating their reburning in circulating fluidized bed decoupling combustion[J]. 中国化学工程学报, 2019, 27(7): 1680-1689.
[15]	Jiajun Song, Dongyan Han, Qinqin Xu, Dan Zhou, Jianzhong Yin. Heat transfer model of two-phase flow across tube bundle in submerged combustion vaporizer[J]. Chinese Journal of Chemical Engineering, 2019, 27(3): 613-619.

Heat Transfer in a Liquid-Solid Circulating Fluidized Bed Reactor with Low Surface Tension Media

Heat Transfer in a Liquid-Solid Circulating Fluidized Bed Reactor with Low Surface Tension Media

PDF (PC)

可视化

摘要/Abstract

引用本文

使用本文

参考文献

相关文章 15

编辑推荐

Metrics

本文评价