A Two-step Design Method for Shaft Work Targeting on Low-temperature Process

doi:10.1016/S1004-9541(14)60081-1

Chinese Journal of Chemical Engineering ›› 2014, Vol. 22 ›› Issue (6): 664-668.DOI: 10.1016/S1004-9541(14)60081-1

• 催化、动力学与反应工程 • 上一篇下一篇

A Two-step Design Method for Shaft Work Targeting on Low-temperature Process

罗祎青¹, 冯胜科¹, 孙长江², 袁希钢¹

1. School of Chemical Engineering and Technology, Tianjin University, Tianjin 300072, China;
2. Beijing Risun Chemical Technologies Institute Company Limited, Beijing 100070, China

收稿日期:2013-08-13 修回日期:2013-09-09 出版日期:2014-06-28 发布日期:2014-06-06
通讯作者: TIAN Wende
基金资助:
Supported by the National Basic Research Program of China (2010CB720500) and the National Natural Science Foundation (21176178).

A Two-step Design Method for Shaft Work Targeting on Low-temperature Process

LUO Yiqing¹, FENG Shengke¹, SUN Changjiang², YUAN Xigang ¹

1. School of Chemical Engineering and Technology, Tianjin University, Tianjin 300072, China;
2. Beijing Risun Chemical Technologies Institute Company Limited, Beijing 100070, China

Received:2013-08-13 Revised:2013-09-09 Online:2014-06-28 Published:2014-06-06
Supported by:
Supported by the National Basic Research Program of China (2010CB720500) and the National Natural Science Foundation (21176178).

摘要/Abstract

摘要： In low-temperature processes, there are interactions between heat exchanger network (HEN) and refrigeration system. The modification on HEN of the chilling train for increasing energy recovery does not always coordinate with the minimum shaft work consumption of the corresponding refrigeration system. In this paper, a systematic approach for optimizing low-temperature system is presented through mathematical method and exergy analysis. The possibility of "pockets", which appears as right nose section in the grand composite curve (EGCC) of the process, is first optimized. The EGCC with the pockets cutting down is designed as a separate part. A case study is used to illustrate the application of the approach for a HEN of a chilling train with propylene and ethylene refrigerant system in an ethylene production process.

关键词: exergy, shaft work, heat exchanger network, cold pocket, low-temperature process, optimization

Abstract: In low-temperature processes, there are interactions between heat exchanger network (HEN) and refrigeration system. The modification on HEN of the chilling train for increasing energy recovery does not always coordinate with the minimum shaft work consumption of the corresponding refrigeration system. In this paper, a systematic approach for optimizing low-temperature system is presented through mathematical method and exergy analysis. The possibility of "pockets", which appears as right nose section in the grand composite curve (EGCC) of the process, is first optimized. The EGCC with the pockets cutting down is designed as a separate part. A case study is used to illustrate the application of the approach for a HEN of a chilling train with propylene and ethylene refrigerant system in an ethylene production process.

Key words: exergy, shaft work, heat exchanger network, cold pocket, low-temperature process, optimization

罗祎青, 冯胜科, 孙长江, 袁希钢. A Two-step Design Method for Shaft Work Targeting on Low-temperature Process[J]. Chinese Journal of Chemical Engineering, 2014, 22(6): 664-668.

LUO Yiqing, FENG Shengke, SUN Changjiang, YUAN Xigang . A Two-step Design Method for Shaft Work Targeting on Low-temperature Process[J]. Chin.J.Chem.Eng., 2014, 22(6): 664-668.

参考文献

1 Linnhoff, B., Ashmad, S., "Super-targeting: Optimal synthesis of energy management systems", Trans. ASME, J. Energy Resources Techno, 111(3), 131-136 (1989).

2 Huang, K.F., Zhang, J.W., Feng, X., "Optimum setting for the utility system of ethylene plant", Chemical Industry and Engineering Progress, 25, 466-469 (2006). (in Chinese)

3 Mehra Yuv, R., "Refrigeration charts for low temperature processes", Chemical Engineering, 15 (1), 131-139 (1979).

4 Shelton, M.R., Grossmann, I.E., "Optimal synthesis of refrigeration systems", Computers and Chemical Engineering, 10(5), 461-477 (1986).

5 Linnhoff, B., "The pinch design method for heat exchanger networks", Chemical Engineering Science, 38 (4), 745-763 (1983).

6 Linnhoff, B., Dhole, V. R., "Shaft work targets for low-temperature process design", Chemical Engineering Science, 47(8), 2081-2091 (1992).

7 Rosen, M.A., Dincer, I., "Exergy as the confluence of energy, environment and sustainable development", International Journal of Exergy, 1(1), 3-13 (2001).

8 Linnhoff, B., "Pinch technology for the synthesis of optimal heat and power systems", Trans ASME, J. Energy Resources Technol, 111(3), 137-147 (1989).

9 Hui, C.W., Ahmad, S., "Total site heat integration using the utility system", Computers and Chemical Engineering, 18(8), 729-742 (1994).

10 Panjeshahi, M. H., Langeroudi, E.G., Tahouni, N., "Retrofit of ammonia plant for improving energy efficiency", Energy, 33(1), 46-64 (2008).

11 Umeda, T., "A thermodynamic approach to the synthesis of heat integration systems in chemical processes", Computers and Chemical Engineering, 3(1-4), 273-282 (1979).

12 Dhole, V. R., "Distillation column integration and overall design of sub-ambient plants", Ph.D. Thesis, University of Manchester (UMIST), England (1991).

13 Wang, Y.F., Feng, X., Cai, Y., Zhu, M.B., Chu, K.H., "Improving a process's efficiency by exploiting heat pockets in its heat exchange network", Energy, 34(11), 1925-1932 (2009).

14 Luo, Y.Q., Yuan, X.G., Liu, Y.J., "An improved PSO algorithm for solving non-convex NLP/MINLP problems with equality constraints", Computers and Chemical Engineering, 31, 153-162 (2007).

15 Luo, Y.Q., Yuan, X.G., "Global optimization for the synthesis of integrated water systems with particle swarm optimization algorithm", Chin. J. Chem. Eng., 16(1), 11-15 (2008).

[1]	Chuang Liang, Zhihao Liu, Baochang Sun, Haikui Zou, Guangwen Chu. Improvement in discharge characteristics and energy yield of ozone generation via configuration optimization of a coaxial dielectric barrier discharge reactor[J]. 中国化学工程学报, 2023, 60(8): 61-68.
[2]	Yaran Bu, Changchun Wu, Lili Zuo, Qian Chen. The calculation and optimal allocation of transmission capacity in natural gas networks with MINLP models[J]. 中国化学工程学报, 2023, 59(7): 251-261.
[3]	Danlei Chen, Yiqing Luo, Xigang Yuan. Cascade refrigeration system synthesis based on hybrid simulated annealing and particle swarm optimization algorithm[J]. 中国化学工程学报, 2023, 58(6): 244-255.
[4]	Yanli Zhang, Zhengkun Hou, Dong Yao, Xiaomin Qiu, Hongru Zhang, Peizhe Cui, Yinglong Wang, Jun Gao, Zhaoyou Zhu, Limei Zhong. Energy, exergy, economic and environmental comprehensive analysis and multi-objective optimization of a sustainable zero liquid discharge integrated process for fixed-bed coal gasification wastewater[J]. 中国化学工程学报, 2023, 58(6): 341-354.
[5]	Jikai Dong, Bing Wang, Xinjie Wang, Chenxi Cao, Shikuan Chen, Wenli Du. Optimization of sensor deployment sequences for hazardous gas leakage monitoring and source term estimation[J]. 中国化学工程学报, 2023, 56(4): 169-179.
[6]	Dandan Ren, Shanshan Xiang, Yuwen Yan, Ruiying Kong, Xingchu Gong. Design and optimization of purification process of sinomenine hydrochloride[J]. 中国化学工程学报, 2023, 55(3): 63-72.
[7]	Yingjun Lin. Whole-process optimization for industrial production of glucosamine sulfate sodium chloride based on QbD concept[J]. 中国化学工程学报, 2023, 54(2): 153-161.
[8]	Shan Liu, Wenqi Zhong, Xi Chen, Li Sun, Lukuan Yang. Multiobjective economic model predictive control using utopia-tracking for the wet flue gas desulphurization system[J]. 中国化学工程学报, 2023, 54(2): 343-352.
[9]	Chao Zhang, Youzhi Liu, Weizhou Jiao, Hongyan Shen, Xigang Yuan, Shengkun Jia. An optimization method for enhancement of gas–liquid mass transfer in a bubble column reactor based on the entropy generation extremum principle[J]. 中国化学工程学报, 2023, 53(1): 83-88.
[10]	Monique Juna L. Leite, Ingrid Ramalho Marques, Mariane Carolina Proner, Pedro H.H. Araújo, Alan Ambrosi, Marco Di Luccio. Catalytically active membranes for esterification: A review[J]. 中国化学工程学报, 2023, 53(1): 142-154.
[11]	Xinqiang You, Kai Zhao, Ling Li, Ting Qiu. Ionic liquids as entrainer in extractive distillation for effectively separating 1-propanol–water azeotropic mixture[J]. 中国化学工程学报, 2022, 49(9): 224-233.
[12]	Jia Ren, Zengqiang Chen, Mingwei Sun, Qinglin Sun, Zenghui Wang. Proportion integral-type active disturbance rejection generalized predictive control for distillation process based on grey wolf optimization parameter tuning[J]. 中国化学工程学报, 2022, 49(9): 234-244.
[13]	Na Wang, Chong Peng, Zhenmin Cheng, Zhiming Zhou. Molecular reconstruction of vacuum gas oils using a general molecule library through entropy maximization[J]. 中国化学工程学报, 2022, 48(8): 21-29.
[14]	Chun Deng, Xuantong Lu, Qixin Zhang, Jian Liu, Jui-Yuan Lee, Xiao Feng. Fuzzy optimization design of multicomponent refinery hydrogen network[J]. 中国化学工程学报, 2022, 48(8): 125-139.
[15]	Zhigang Xu, Xiongfei Jin, Tao Zhou, Qian Zou, Longcheng Liu, zhongbo Wang, Hanbing Sheng, Huasheng Xie. Preparation of aldoxime through direct ammoximation using titanium silicalite-1 catalyst[J]. 中国化学工程学报, 2022, 47(7): 11-17.

A Two-step Design Method for Shaft Work Targeting on Low-temperature Process

A Two-step Design Method for Shaft Work Targeting on Low-temperature Process

PDF (PC)

可视化

摘要/Abstract

引用本文

使用本文

参考文献

相关文章 15

编辑推荐

Metrics

本文评价