SCI和EI收录∣中国化工学会会刊

Chinese Journal of Chemical Engineering ›› 2014, Vol. 22 ›› Issue (1): 104-112.DOI: 10.1016/S1004-9541(14)60020-3

• 能源、资源与环境技术 • 上一篇    下一篇

Steam Reforming of Dimethyl Ether by Gliding Arc Gas Discharge Plasma for Hydrogen Production

王保伟, 孙启梅, 吕一军, 杨美琳, 闫文娟   

  1. Key Laboratory for Green Chemical Technology, School of Chemical Engineering Technology, Tianjin University, Tianjin 300072, China
  • 收稿日期:2012-04-16 修回日期:2012-10-08 出版日期:2014-01-05 发布日期:2014-01-04
  • 通讯作者: WANG Baowei
  • 基金资助:

    Supported by the National Natural Science Foundation of China (21176175, 20606023).

Steam Reforming of Dimethyl Ether by Gliding Arc Gas Discharge Plasma for Hydrogen Production

WANG Baowei, SUN Qimei, LÜ Yijun, YANG Meilin, YAN Wenjuan   

  1. Key Laboratory for Green Chemical Technology, School of Chemical Engineering Technology, Tianjin University, Tianjin 300072, China
  • Received:2012-04-16 Revised:2012-10-08 Online:2014-01-05 Published:2014-01-04
  • Contact: WANG Baowei
  • Supported by:

    Supported by the National Natural Science Foundation of China (21176175, 20606023).

摘要: Gliding arc gas discharge plasma was used for the generation of hydrogen from steam reforming of dimethyl ether (DME). A systemic procedure was employed to determine the suitable experimental conditions. It was found that DME conversion first increased up to the maximum and then decreased slightly with the increase of added water and air. The increase of total feed gas flow rate resulted in the decrease of DME conversion and hydrogen yield, but hydrogen energy consumption dropped down to the lowest as total feed gas flow rate increased to 76 ml·min-1. Larger electrode gap and higher discharge voltage were advantageous. Electrode shape had an important effect on the conversion of DME and production of H2. Among the five electrodes, electrode 2# with valid length of 55 mm and the radian of 34 degrees of the top electrode section was the best option, which enhanced obviously the conversion of DME.

关键词: dimethyl ether, steam reforming, hydrogen production, gliding arc gas discharge

Abstract: Gliding arc gas discharge plasma was used for the generation of hydrogen from steam reforming of dimethyl ether (DME). A systemic procedure was employed to determine the suitable experimental conditions. It was found that DME conversion first increased up to the maximum and then decreased slightly with the increase of added water and air. The increase of total feed gas flow rate resulted in the decrease of DME conversion and hydrogen yield, but hydrogen energy consumption dropped down to the lowest as total feed gas flow rate increased to 76 ml·min-1. Larger electrode gap and higher discharge voltage were advantageous. Electrode shape had an important effect on the conversion of DME and production of H2. Among the five electrodes, electrode 2# with valid length of 55 mm and the radian of 34 degrees of the top electrode section was the best option, which enhanced obviously the conversion of DME.

Key words: dimethyl ether, steam reforming, hydrogen production, gliding arc gas discharge