Fluid Flow and Heat Transfer Characteristic of Outer and Inner Half Coil Jackets

›› 2011, Vol. 19 ›› Issue (2): 253-261.

Fluid Flow and Heat Transfer Characteristic of Outer and Inner Half Coil Jackets

李雅侠^1,2, 吴剑华¹, 战洪仁², 王翠华¹

1. School of Chemical Engineering & Technology, Tianjin University, Tianjin 300072, China;
2. School of Mechanical Engineering, Shenyang University of Chemical Technology, Shenyang 110142, China

收稿日期:2010-08-25 修回日期:2010-11-16 出版日期:2011-04-28 发布日期:2011-04-28
通讯作者: WU Jianhua,E-mail:Jianhuawu@163.com
基金资助:
Supported by the National Key Technologies Research and Development Program during the 10th Five-year Plan Period(2004BA319B1);the Educational Commission of Liaoning Province of China(2008S117)

Fluid Flow and Heat Transfer Characteristic of Outer and Inner Half Coil Jackets

LI Yaxia^1,2, WU Jianhua¹, ZHAN Hongren², WANG Cuihua¹

1. School of Chemical Engineering & Technology, Tianjin University, Tianjin 300072, China;
2. School of Mechanical Engineering, Shenyang University of Chemical Technology, Shenyang 110142, China

Received:2010-08-25 Revised:2010-11-16 Online:2011-04-28 Published:2011-04-28
Supported by:
Supported by the National Key Technologies Research and Development Program during the 10th Five-year Plan Period(2004BA319B1);the Educational Commission of Liaoning Province of China(2008S117)

摘要/Abstract

摘要： The physical models of the outer and inner half coil jackets were simplified to two types of coiled ducts.The mathematic models of incompressible fluid at the condition of laminar flow and heat transfer in the two types of jackets for cooling process reactor were set up and solved by the semi-implicit method for pressure linked equations consistent (SIMPLEC) algorithm based on a control volume method.The flow and temperature fields were given and the effects of Dean and Prandtl numbers on flow and heat transfer were studied.The results show that flow in the inner half coil jacket is found to exhibit transition of secondary flow pattern from two vortices to four vortices when the Dean number increases,but that in the outer half coil jacket is not found.The critical Dean number is about 96.The inner half coil jacket has stronger heat transfer ability than the outer half coil jacket and this superiority is more evident with larger Prandtl number.However,as the Dean number is greater than 105,the flow resistance enhances more severely in the inner jacket than the outer jacket.For both jackets,the centers of the heated wall are the poorest for heat transfer.

关键词: half coil jacket, secondary flow, temperature field, heat transfer enhancement

Abstract: The physical models of the outer and inner half coil jackets were simplified to two types of coiled ducts.The mathematic models of incompressible fluid at the condition of laminar flow and heat transfer in the two types of jackets for cooling process reactor were set up and solved by the semi-implicit method for pressure linked equations consistent (SIMPLEC) algorithm based on a control volume method.The flow and temperature fields were given and the effects of Dean and Prandtl numbers on flow and heat transfer were studied.The results show that flow in the inner half coil jacket is found to exhibit transition of secondary flow pattern from two vortices to four vortices when the Dean number increases,but that in the outer half coil jacket is not found.The critical Dean number is about 96.The inner half coil jacket has stronger heat transfer ability than the outer half coil jacket and this superiority is more evident with larger Prandtl number.However,as the Dean number is greater than 105,the flow resistance enhances more severely in the inner jacket than the outer jacket.For both jackets,the centers of the heated wall are the poorest for heat transfer.

Key words: half coil jacket, secondary flow, temperature field, heat transfer enhancement

李雅侠, 吴剑华, 战洪仁, 王翠华. Fluid Flow and Heat Transfer Characteristic of Outer and Inner Half Coil Jackets[J]. , 2011, 19(2): 253-261.

LI Yaxia, WU Jianhua, ZHAN Hongren, WANG Cuihua. Fluid Flow and Heat Transfer Characteristic of Outer and Inner Half Coil Jackets[J]. , 2011, 19(2): 253-261.

参考文献

1 Garvin, J., “Understand the thermal design of jacketed vessels”, Chem. Eng. Prog., 95 (6), 61-68 (1999).
2 Dhotre, M.T., Murthy, Z.V.P., Jayakumar, N.S., “Modeling and dynamic studies of heat transfer cooling of liquid in half coil jackets”, Chem. Eng. J., 118 (3), 183-188 (2006).
3 Jayakumar, N.S., Mjalli, F.S., “The dynamics of liquid cooling in half-coil jackets”, Chem. Prod. Process Model., 3 (1), 1-16 (2008).
4 Wang, Q.W., “Spiral semicircle pipe jacket reactor in the emulsion polymerization”, China Adhesives, 11 (2), 48-49 (2002). (in Chinese)
5 Mao, L.R., Bing, J.L., He, G.L., “PVC polymerizer with complete flowthrough inner jacket”, CN Pat., 200520045285.7 (2006).
6 Naphon, P., Wongwises, S., “A review of flow and heat transfer characteristics in curved tubes”, Renew. Sust. Energy Rev., 10 (5), 463-490 (2006).
7 Cioncolini, A., Santini, L., “An experimental investigation regarding the laminar to turbulent flow transition in helically coiled pipes”, Exp. Therm. Fluid Sci., 30 (4), 367-380 (2006).
8 Ghorbani, N., Taherian, H., Gorji, M., “Experimental study of mixed convection heat transfer in vertical helically coiled tube heat exchangers”, Exp. Therm. Fluid Sci., 34 (7), 900-905 (2010).
9 Nobari, M.R.H., Ahrabi, B.R., Akbari, G., “A numerical analysis of developing flow and heat transfer in a curved annular pipe”, Int. J. Therm. Sci., 48 (8), 1542-1551 (2009).
10 Conte, I., Peng, X.F., “Numerical investigations of laminar flow in coiled pipes”, Appl. Therm. Eng., 28 (5), 423-432 (2008).
11 Jayakumara, J.S., Mahajania, S.M., Mandala, J.C., “CFD analysis of single-phase flows inside helically coiled tubes”, Comput. Chem. Eng., 34 (4), 430-446 (2010).
12 Chen, Y.T., Chen, H.J., Zhang, B.Z., “Fluid flow and convective heat transfer in a rotating helical square duct”, Int. J. Therm. Sci., 45 (10), 1008-1020 (2006).
13 Papadopoulos, P.K., Hatzikonstantinou, P.M., “Numerical investigation of the thermally developing flow in a curved elliptic duct with internal fins”, J. Heat Transfer, 129 (7), 759-762 (2007).
14 Ishigaki, H., “Analogy of forced convective heat transfer between laminar flows in curved pipes and orthogonally rotating pipes”, JSME Int. J. Ser. B, 42 (1), 48-55 (1999).
15 Zhang, J.W., Zhang, Z., “ A numerical study on fully developed fluid flow and heat transfer in a spiral finned tube”, Chin. J. Chem. Eng., 7 (1), 56-66 (1999).
16 Patankar, S.V., Numerical Heat Transfer and Fluid Flow, Hemisphere, New York (1980).
17 Erdogan, M.E., Imrak, C.E., “Effects of the sidewalls on starting flows in ducts”, Int. J. Nonlin. Mech., 40 (1), 103-111 (2005).
18 Etemad, S.G.H., Mujumdar, A.S., “Effects of variable viscosity and viscous dissipation on laminar convection heat transfer of power law fluid in the entrance region of a semi-circular duct”, Int. J. Heat Mass Transfer, 38 (12), 2225-2238 (1995).
19 Nobari, M.R.H., Gharali, K., “A numerical study of flow and heat transfer in internally finned rotating straight pipes and stationary curved pipes”, Int. J. Heat Mass Transfer, 49 (5), 1185-1194 (2006).
20 Cheng, K.C., Lin, R.C., Ou, J.W., “ Fully developed laminar flow in curved rectangular channels ”, J. Fluids Eng., 98, 41-48 (1976).
21 Winters, K.H., “A bifurcation study of laminar flow in a curved tube of rectangular cross section”, J. Fluid Mech., 180, 343-369 (1987).
22 Prabhanjan, D.G., Ragbavan, G.S.V., Kennic, T.J., “Comparison of heat transfer rates between a straight tube heat exchanger and a helically coiled heat exchanger”, Int. Commun. Heat Mass Transfer, 29 (2), 185-191 (2002).
23 Zachár, A., “Analysis of coiled-tube heat exchangers to improve heat transfer rate with spirally corrugated wall”, Int. J. Heat Mass Transfer, 53 (19), 3928-3939 (2010).

[1]	Feng Jiang, Di Xu, Ruijia Li, Guopeng Qi, Xiulun Li. Particle collision behavior and heat transfer performance in a Na₂SO₄ circulating fluidized bed evaporator[J]. 中国化学工程学报, 2022, 46(6): 40-52.
[2]	Yonghou Xiao, Shuang Qiu, Qidong Zhao, Yuhao Zhu, Chirag B. Godiya, Gaohong He. Numerical simulation of low-concentration CO₂ adsorption on fixed bed using finite element analysis[J]. 中国化学工程学报, 2021, 36(8): 47-56.
[3]	Chuanshuai Dong, Lin Lu, Tao Wen, Shaojie Zhang. Thermal performance assessment of self-rotating twisted tapes and Al₂O₃ nanoparticle in a circular pipe[J]. 中国化学工程学报, 2021, 32(4): 77-86.
[4]	Krunal M. Gangawane, Hakan F. Oztop. Mixed convection in the heated semi-circular lid-driven cavity for nonNewtonian power-law fluids: Effect of presence and shape of the block[J]. 中国化学工程学报, 2020, 28(5): 1225-1240.
[5]	Xiaodong Jing, Hao Wen, Zhihong Xu. Temperature field simulation of polyolefin-absorber mixture by FDTD-FDM model during microwave heating[J]. 中国化学工程学报, 2020, 28(11): 2900-2917.
[6]	P. Soleimani, M. Khoshvaght-Aliabadi, H. Rashidi, H. Bahmanpour. Performance enhancement of water bath heater at natural gas city gate station using twisted tubes[J]. 中国化学工程学报, 2020, 28(1): 165-179.
[7]	Yongliang Wan, Runhan Wu, Cong Qi, Gang Duan, Ruizhao Yang. Experimental study on thermo-hydraulic performances of nanofluids flowing through a corrugated tube filled with copper foam in heat exchange systems[J]. Chinese Journal of Chemical Engineering, 2018, 26(12): 2431-2440.
[8]	Pedram Karimi Pour-Fard, Ebrahim Afshari, Masoud Ziaei-Rad, Shahed Taghian-Dehaghani. A numerical study on heat transfer enhancement and design of a heat exchanger with porous media in continuous hydrothermal flow synthesis system[J]. , 2017, 25(10): 1352-1359.
[9]	Pedram Karimi Pour-Fard, Ebrahim Afshari, Masoud Ziaei-Rad, Shahed Taghian-Dehaghani. A numerical study on heat transfer enhancement and design of a heat exchanger with porous media in continuous hydrothermal flow synthesis system[J]. , 2017, 25(10): 1352-1359.
[10]	M. Khoshvaght-Aliabadi, M. H. Akbari, F. Hormozi. An empirical study on vortex-generator insert fitted in tubular heat exchangers with dilute Cu-water nanofluid flow[J]. Chinese Journal of Chemical Engineering, 2016, 24(6): 728-736.
[11]	Cong Dong, Yaping Chen, Jiafeng Wu . Comparison of heat transfer performances of helix baffled heat exchangers with different baffle configurations[J]. Chinese Journal of Chemical Engineering, 2015, 23(1): 255-261.
[12]	李国能, 郑友取, 胡桂林, 张治国. Convective Heat Transfer Enhancement of a Rectangular Flat Plate by an Impinging Jet in Cross Flow[J]. Chinese Journal of Chemical Engineering, 2014, 22(5): 489-495.
[13]	Smith Eiamsa-ard, Vichan Kongkaitpaiboon, Kwanchai Nanan. Thermohydraulics of Turbulent Flow Through Heat Exchanger Tubes Fitted with Circular-rings and Twisted Tapes[J]. Chinese Journal of Chemical Engineering, 2013, 21(6): 585-593.
[14]	Thangavelu Perarasu, Mahizhnan Arivazhagan, Palani Sivashanmugam. Experimental and CFD Heat Transfer Studies of Al₂O₃-Water Nanofluid in a Coiled Agitated Vessel Equipped with Propeller[J]. Chinese Journal of Chemical Engineering, 2013, 21(11): 1232-1243.
[15]	王翠华, 刘胜举, 吴剑华, 李雅侠. Laminar Flow and Heat Transfer Characteristics in Jackets of Triangular Flow Channels[J]. Chinese Journal of Chemical Engineering, 2013, 21(11): 1224-1231.

Fluid Flow and Heat Transfer Characteristic of Outer and Inner Half Coil Jackets

Fluid Flow and Heat Transfer Characteristic of Outer and Inner Half Coil Jackets

PDF (PC)

可视化

摘要/Abstract

引用本文

使用本文

参考文献

相关文章 15

编辑推荐

Metrics

本文评价